justin_o_guy2
Serious Thumper
Offline
What happened?
Posts: 55279
East Texas, 1/2 dallas/la.
|
It wasnt tite, so getting it out should be easy. If you dont wanna drive an extractor in it & knock porcelain into the jug, I get that.. Piano wire, 1/8" bits even, theyre cheap, OR 2 skinny extractors,, drill holes in the threaded slug, punch the wire/ drill bit ends, extractors, whatever, into the holes & use that to back it out.
Now, get a piece of wire, put a skinny loop on it, get some grease & dab on it, THINK about where that end is, walk it down the wall till it hits the piston, swing it around the Piston/wall junctiona few degrees, pull it out, look for signs of debris,,Spend time here, maybe even lay the bike on its side& smak the jug w/ a board to make anything want to go to one side,,but you need to know theres no busted glass in there,,
If you have a compressor you can build a vacuum of sorts.
Youll need a blower tip with a skinny, long nozzle tip. I added a 1/8th tubing to one of mine, poke a hole in a piece of tubing about 6 inches from the end, insert nozzle, aimed out the short end, when ya pull the trigger it creates a vacuum on the other end, Ive used that setup a number of times, Itll move fluids..
|