SuzukiSavage.com - Ring Gap

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Ring Gap

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Ring Gap (Read 27 times)

Dennisgb Full Member Offline SuzukiSavage.com Rocks! Posts: 176 Maplewood MN Gender:	Ring Gap 05/13/20 at 15:56:27 Just want to verify ring gap. I’m re-ringing a stock piston no rebore. I am reading .004” per inch of piston diameter. Also a range of 012-016” which is approximately the same. Any help appreciated.
Back to top	IP Logged

DragBikeMike Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 4207 Honolulu	Re: Ring Gap Reply #1 - 05/13/20 at 16:43:07 Stock ring end gap specification is .012" t .018" with a wear limit of .039". Keep in mind that for every .001" increase in bore diameter your end gap will increase about .003", so if your bore is worn .001" oversize your end gap will increase about .003".
Back to top	Knowledge is power. IP Logged

Dennisgb

Full Member

Offline

SuzukiSavage.com
Rocks!

Posts: 176
Maplewood MN
Gender: male

Re: Ring Gap
Reply #2 - 05/13/20 at 18:07:06

DragBikeMike wrote on 05/13/20 at 16:43:07:

Stock ring end gap specification is .012" t .018" with a wear limit of .039".

Keep in mind that for every .001" increase in bore diameter your end gap will increase about .003", so if your bore is worn .001" oversize your end gap will increase about .003".

Thanks.

Got it. New rings so I will be setting the end gap

IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home