SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Ring Gap /cgi-bin/YaBB.pl?num=1589410588 Message started by Dennisgb on 05/13/20 at 15:56:27

Title: Ring Gap Post by Dennisgb on 05/13/20 at 15:56:27 Just want to verify ring gap. I’m re-ringing a stock piston no rebore. I am reading .004” per inch of piston diameter. Also a range of 012-016” which is approximately the same. Any help appreciated.

Title: Re: Ring Gap Post by DragBikeMike on 05/13/20 at 16:43:07 Stock ring end gap specification is .012" t .018" with a wear limit of .039". Keep in mind that for every .001" increase in bore diameter your end gap will increase about .003", so if your bore is worn .001" oversize your end gap will increase about .003".

Title: Re: Ring Gap Post by Dennisgb on 05/13/20 at 18:07:06 46404F33313632020 wrote: Stock ring end gap specification is .012" t .018" with a wear limit of .039". Keep in mind that for every .001" increase in bore diameter your end gap will increase about .003", so if your bore is worn .001" oversize your end gap will increase about .003". Thanks. Got it. New rings so I will be setting the end gap

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.