SuzukiSavage.com

skiian

YaBB Newbies

Offline

SuzukiSavage.com
Rocks!

Posts: 4

Re: JETSETS
Reply #210 - 06/02/14 at 09:10:36

I'd be interested in a set, but first can someone point me to a good guide on how to do this on a savage/S40? I've never re-jetted a carb so this should be quite the learning experience.

The previous owner put a freer flowing exhaust on, and it's a little laggy/lurchy in the low RPM 10-20mph zone. It sounds like a jetting problem to me, do you agree?

Back to top

IP Logged

extraparts YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 3	Re: JETSETS Reply #211 - 06/02/14 at 13:04:12 Hi, Lancer. I was wondering if you had a jet set put together or would have one soon. I wasn't sure if I should just Paypal you a fistfull of money and then wait by my mailbox or talk to you first. Also, with shipping to MN, the cost is just $24.95 total? Thanks in advance!
Back to top	IP Logged

extraparts YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 3	Re: JETSETS Reply #212 - 06/02/14 at 13:07:42 Skiian, There is good info right here on the SuzukiSavage site. http://suzukisavage.com/cgi-bin/YaBB.pl?board=tech;action=display;num=1157720585 Or go here for a super helpful contents list of the whole site: http://suzukisavage.com/cgi-bin/YaBB.pl?num=1181745927
Back to top	IP Logged

YoungSavage Junior Member Offline everyone knows I'm home by the KA-POW! Posts: 89 Monterey, California Gender:	Re: JETSETS Reply #213 - 06/03/14 at 23:10:14 Lancer I was curious if you sold single jets instead of sets? I only need a 152.5 and 52.5 because my stock jets are from the 88 savage.
Back to top	1988 Stock, mixture screw out 2 turns, seat lift mod, elevation= sea level, main jet=155 pilot jet=55 IP Logged

zSavage

YaBB Newbies

Offline

SuzukiSavage.com
Rocks!

Posts: 9

Re: JETSETS
Reply #214 - 06/09/14 at 10:59:56

hello,

New owner here... and not much of a mechanic.... am able to do stuff just dont' know much...

So i have this bike with straight pipe and stock air and carb..I bought it this way...It backfires a lot and I can ride it smooth with little backfire if i'm rela gentle on teh trottle...

but just normal lots pops and pud backfires.
Also when shut down most ofter i hear a loud puff or plop... hard to explain..

SO....
How do i figure out what kinda jets to replace to make it stop this?

Also does carb come off each time i do this.... or can you get at it from bottom woiht out carb removal

Thanks for your help if you have time...

z-

Back to top

IP Logged

oh_hi_bear

YaBB Newbies

Offline

SuzukiSavage.com
Rocks!

Posts: 10
california
Gender: male

Re: JETSETS
Reply #215 - 06/10/14 at 21:50:36

LANCER wrote on 05/22/14 at 03:10:27:

oh_hi_bear wrote on 05/21/14 at 23:36:20:

LANCER wrote on 05/21/14 at 05:20:41:

oh_hi_bear wrote on 05/20/14 at 22:51:08:

Hi Lancer,

I need jets size slightly different from your jet sets and a float bowl gasket.

pilot #50 52.5
main #157.5 160

Can you PM me and let me know what you have and the price with shipping. I live in California. I am unable to PM you due to my lack of posts. Thanks.

If you let me know right away, I can order the 157.5 main jet with my next order; should have it in about 10 days.
Gaskets ? ? ? will just have to wait and see if they are available yet; stuff is getting hard to get. Yea, it's crazy.

I do want to order the 157.5 main jet. I already send the payment for the other 3 jets. Since the wait is only 10 days, I can wait for you to send them all in one package. Just let me know what is the additional cost and I will send the second payment.

Okie dokie, will do

Have the 157.5 main jet arrive yet?

Back to top

IP Logged

LANCER

Serious Thumper
Alliance Member

Offline

Savage Beast
Performance Parts

Posts: 10606
Oklahoma
Gender: male

Re: JETSETS
Reply #216 - 06/14/14 at 05:12:31

oh_hi_bear wrote on 06/10/14 at 21:50:36:

LANCER wrote on 05/22/14 at 03:10:27:

oh_hi_bear wrote on 05/21/14 at 23:36:20:

LANCER wrote on 05/21/14 at 05:20:41:

oh_hi_bear wrote on 05/20/14 at 22:51:08:

Hi Lancer,

I need jets size slightly different from your jet sets and a float bowl gasket.

pilot #50 52.5
main #157.5 160

Can you PM me and let me know what you have and the price with shipping. I live in California. I am unable to PM you due to my lack of posts. Thanks.

If you let me know right away, I can order the 157.5 main jet with my next order; should have it in about 10 days.
Gaskets ? ? ? will just have to wait and see if they are available yet; stuff is getting hard to get. Yea, it's crazy.

I do want to order the 157.5 main jet. I already send the payment for the other 3 jets. Since the wait is only 10 days, I can wait for you to send them all in one package. Just let me know what is the additional cost and I will send the second payment.

Okie dokie, will do

Have the 157.5 main jet arrive yet?

Was ordering parts Thursday and checked on this; the 157.5 main jets are still on back order and expected to come in from Japan the first week of July. Yea. Crazy.

Back to top

IP Logged

LANCER

Serious Thumper
Alliance Member

Offline

Savage Beast
Performance Parts

Posts: 10606
Oklahoma
Gender: male

Re: JETSETS
Reply #217 - 06/14/14 at 05:43:47

zSavage wrote on 06/09/14 at 10:59:56:

hello,

New owner here... and not much of a mechanic.... am able to do stuff just dont' know much...

So i have this bike with straight pipe and stock air and carb..I bought it this way...It backfires a lot and I can ride it smooth with little backfire if i'm rela gentle on teh trottle...

but just normal lots pops and pud backfires.
Also when shut down most ofter i hear a loud puff or plop... hard to explain..

SO....
How do i figure out what kinda jets to replace to make it stop this?

Also does carb come off each time i do this.... or can you get at it from bottom woiht out carb removal

Thanks for your help if you have time...

z-

Howdy Z: If possible, you want to do away with that straight pipe. It is just real loud and hurts performance and makes tuning difficult.
An older HD dyna is a good cheap replacement, or you can buy new mufflers for more $$$$; just be sure to get a good one so you are not wasting your money. The least expensive quality built mufflers I've found are from Cone Engineering.

http://www.coneeng.com/pdf/motorcycle/MC%20finsihed%20Mufflers%20PDF.pdf

In order to have a good smooth running engine that does not backfire you need to have a good muffler and an air-tight exhaust system. Any air leaks at all with cause back firing and frustrate the heck out of you as you try to tune the carb, which will just not act right at all as long as there is an air leak in the system. Fortunately, with just one cylinder to deal with we only have to ensure that the head-to-header, and header-to-muffler connections are air tight ... assuming that there are no other holes somewhere else that may be due to "rust-through" etc.

Of course, you also need to have a good air intake filtering system.
The stock air filter is good, but if you want to go with a pod type then be sure it is a good filter, is kept clean and sealed well to keep out crud.

So; good muffler, good air-tight exhaust system, jet/tune carb to match intake & exhaust system.
If you are in need of jets let me know. Currently I have them.

Back to top

IP Logged

LANCER Serious Thumper Alliance Member Offline Savage Beast Performance Parts Posts: 10606 Oklahoma Gender:	Re: JETSETS Reply #218 - 06/14/14 at 05:47:15 YoungSavage wrote on 06/03/14 at 23:10:14: Lancer I was curious if you sold single jets instead of sets? I only need a 152.5 and 52.5 because my stock jets are from the 88 savage. Yes, I can do that. The 2 jets + shp + $12 for US addresses. Do you have washers for the needle ? No extra cost for those.
Back to top	IP Logged

Demin Serious Thumper Offline We need more chlorine in the gene pool Posts: 2435 Warren,Ohio Gender:	Re: JETSETS Reply #219 - 06/15/14 at 07:50:23 LANCER..Are the carbs all the same?I didn't recall my '86 having the white spacers.And according to Dynojet,their kits are for '00 and up.Older than that all the same then?
Back to top	Next project:finish '87 Savage custom/bobber/CHOP STYLE***DONE finish '77 Yamaha XS650 bobber Bought another one finish'79 Harley custom bobber(NEXT) IP Logged

LANCER

Serious Thumper
Alliance Member

Offline

Savage Beast
Performance Parts

Posts: 10606
Oklahoma
Gender: male

Re: JETSETS
Reply #220 - 06/16/14 at 03:56:33

Demin wrote on 06/15/14 at 07:50:23:

LANCER..Are the carbs all the same?I didn't recall my '86 having the white spacers.And according to Dynojet,their kits are for '00 and up.Older than that all the same then?

Yep, basically all the same. The 80's models (some, if not all) had a needle with 3 notches in it so the clip could be adjusted rice/lean, but other than that consider them the same.
The 80's models do have the white spacer like all the other models.

When it comes to the LS650, with exception to some electrical items that Suzuki changed over the years, or the 4 to 5 speed change in the tranny, or the starter gear change they made, you can ignore any of the model year restrictions that may be listed by after market manufacturers. It just does not matter.

Back to top

IP Logged

RangerRide YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 18	Re: JETSETS Reply #221 - 06/18/14 at 15:29:40 I'm ready for the jetset. First time using paypal. Do I just email you through paypal to savage.s40@gmail.com ?
Back to top	IP Logged

LANCER Serious Thumper Alliance Member Offline Savage Beast Performance Parts Posts: 10606 Oklahoma Gender:	Re: JETSETS Reply #222 - 06/19/14 at 03:08:21 RangerRide wrote on 06/18/14 at 15:29:40: I'm ready for the jetset. First time using paypal. Do I just email you through paypal to savage.s40@gmail.com ? Yep
Back to top	IP Logged

rapfohl YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 24	Re: JETSETS Reply #223 - 07/01/14 at 15:12:18 Can I get a Jetset with a 145 main jet? Let me know, thanks!
Back to top	IP Logged

LANCER Serious Thumper Alliance Member Offline Savage Beast Performance Parts Posts: 10606 Oklahoma Gender:	Re: JETSETS Reply #224 - 07/05/14 at 05:55:17 rapfohl wrote on 07/01/14 at 15:12:18: Can I get a Jetset with a 145 main jet? Let me know, thanks! Sorry, I don't have any new 145 jets for the sets. There may be a used one somewhere but have not ran across one yet.
Back to top	IP Logged