I bought this after replacing turn signals with LEDs.

https://www.amazon.com/dp/B07D33JGLC

But it's not the same connector. Does anyone know a version that is the same connector, or an adapter, or a simpler solution?

Maybe I didn't explain thoroughly...


I'd rather not cut off the existing connector at this point. Is there a solution to avoid that?

gtenginerd , hind-sight is always 20-20 ,   don't ask !  

Do you know how to remove the female wire termals from the plastic holder that came with you bike ?

clue :
It involves a small wire or safty pin ... opened up



no cutting envolved ...  and  ...  you can put the termals back into the plastic later if you want  
............................

Ok , another clue :

put the small screwdriver/wire/strait pin / what ever - in beside the termal on the side with the spur/knotch/ , the other side will be flat.    Then the wire/w/termal attached will pull out the back side to be clear of the plastic holder.   Then you can see the little spur that holds them in place.  

puting a small amount of inward presure on the wire will help get the spur to release , holding the spur down and gently pull the wire out , easy pea-sey.
.............................................

OK , last clue :

put the empty plastic holder back on the original blinker unit just like it was ... so you can find it ... if you ever need it for anything.

I ended up cutting them since I had my solder stuff out and the blade connectors I needed. Put heat shrink on after the pic and it's working just fine.

I've ordered some LED-FLASHER units (slow boat from China) to fit on another bike (W-650).   So , I'll ask ... Did the new flasher fix the problem ?