People toss a lot of gruff at Rossi, then get to eat some of that gruff later on after he can disclose 100% what he has been doing.
Historically,
his release of informational stuff lags reality by 6 months to a year, so when he gives out CAD representations they turn out to be fairly similar to reality at that point in time.
And if he is under NDA, he can't tell you it only takes half as much of whatever was before to do the same job as it used to do ...... my unsubstantiated guess that these would be
at least 3 megawatts per enclosure, perhaps even higher.
And think of the pretty refrigerator like door as a very pretty form of final radiation / live steam shielding and I think you have its purpose for being there.
The entire enclosure looks sorta refrigerator-like, doesn't it? This refrigerator looking enclosure could also contain a skin-flaying steam leak fairly well, also.
After all, the current known minimum reactor size is the size of a friggn' toothpick, largest known size so far is 2 yards long (but logically can be longer if needs be).
Rossi can output low heat or high heat, light and/or electricity in different ratios depending on configuration and use.
I think we will eventually see something sorta like this, perhaps bigger (or smaller) but with a finished appearance to make a good looking item.
Municipal sized centralized steam plants in Norway and Sweden -- that has been stated as ground zero for the commercial/industrial roll out for E-CAT.
Remember Hydrofusion has always had this area as their distributor fiefdom and they have never stopped working on their roll out plans because of IH or Cherokee acting the arse over in America.