1st question is how do I make my stock exhaust louder. I'm thinking about drilling holes. If this is a possible route where should I drill? Second where is the fuel air screw? Thanks for any assistance.

Sal

all QUESTIONS about the savage go in rubber side down.

Quote:


The air screw is located on the right side of the carb, under a brass plug.  The way to access it is to very carefully drill a hole into the brass plug, it is about the thickness of a nickel.  Then run a sheet metal screw or something similar into that hole and pry/pull the plug out.  You will then see the adjustment screw down in the recess.

Quote:


Some have drilled holes and were satisfied with the results.  There are good pictures somewhere in the forum.  I think, but am not sure, that most drill four or five 3/16 inch holes in the back plate at the back end of the muffler.  I don't remember if they put them inside or outside the circle defined by the rivets.