axa
Full Member
Offline
SuzukiSavage.com Rocks!
Posts: 104
|
well apparently mr Lancer is not monitoring this post or keeping the secret to himself. his right either way.
Anyway, you can use part # M-VM36-200, i received mine the other day and its fine. It has 8mm bolt holes, so i just plugged those and drilled out new ones, for the 6mm bolts. But since both combinations end up to be 78mm on the outside measure, you dont really need to do this, just tightening it down tight should be suffice.
i didnt order my cable from barnett yet because i haven't finished fabricating the frame and deciding on risers, but doing this yourself will save me/you over $150. And that includes carb, needle jet, 10 main jets, a few pilots, flange, and 75$ for a cable, but doubt a cable will cost that much. The choice is yours, but i wouldnt say that's just a few bucks.
I suppose if your in a rush and not doing this for fun you might find it a bothersome, but i dont know many who find hot rodding a chore.
|