SuzukiSavage.com - Noisy Engine

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Noisy Engine

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Noisy Engine (Read 3 times)

Kropatchek

Serious Thumper

Offline

Why more than 1
cylinder?

Posts: 1457
Alphen a/d Rijn Netherlands
Gender: male

Noisy Engine
09/14/05 at 06:25:46

http://www.ls-650.de/community/forum/YaBB.pl/YaBB.pl?board=Technik;action=dis...

Check-out these beautifull pictures following a replacement of the cylinderhead by a "Proffesional" workshop.

#1 The chain tensioner fully out because the head was changed without taking the RH side of the engine off to block the chain tensioner.

#2 Camshaft secondaire bearing surface run down.
Camchain was too tight

#3 And again toooooo much sealing for the headcover.

Rest of the discussion not worth translating

Greetz
Kropatchek Grin

Never ask your bike to scream before her throat is warm.
'93 Sav in '96 ( yellow) looks

IP Logged

Savage_Greg

Serious Thumper
Alliance Member

Offline

Don't go around your
ass to reach your
elbow...

Posts: 7844
SW Washington State
Gender: male

Re: Noisy Engine
Reply #1 - 10/02/05 at 09:08:05

Kropatchek wrote on 12/31/69 at 16:00:09:

Good photos....too bad I can't read it.

The issue of sealer is really important too. A little bit goes a long way too.

IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home