SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Noisy Engine /cgi-bin/YaBB.pl?num=1126704346 Message started by Kropatchek on 09/14/05 at 06:25:46

Title: Noisy Engine Post by Kropatchek on 09/14/05 at 06:25:46 http://www.ls-650.de/community/forum/YaBB.pl/YaBB.pl?board=Technik;action=display;num=1126288350;start=0#0 Check-out these beautifull pictures following a replacement of the cylinderhead by a "Proffesional" workshop. #1 The chain tensioner fully out because the head was changed without taking the RH side of the engine off to block the chain tensioner. #2 Camshaft secondaire bearing surface run down.      Camchain was too tight #3 And again toooooo much sealing for the headcover. Rest of the discussion not worth translating Greetz Kropatchek ;D

Title: Re: Noisy Engine Post by Greg_650 on 10/02/05 at 09:08:05 Kropatchek wrote: http://www.ls-650.de/community/forum/YaBB.pl/YaBB.pl?board=Technik;action=display;num=1126288350;start=0#0 Check-out these beautifull pictures following a replacement of the cylinderhead by a "Proffesional" workshop. #1 The chain tensioner fully out because the head was changed without taking the RH side of the engine off to block the chain tensioner. #2 Camshaft secondaire bearing surface run down.      Camchain was too tight #3 And again toooooo much sealing for the headcover. Rest of the discussion not worth translating Greetz Kropatchek ;D Good photos....too bad I can't read it. The issue of sealer is really important too.  A little bit goes a long way too.

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.