SuzukiSavage.com - JB Weld Cam Chain Tensioner?

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › JB Weld Cam Chain Tensioner?

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

JB Weld Cam Chain Tensioner? (Read 31 times)

2009 LS650 S40 Boulevard

YaBB Newbies

Offline

SuzukiSavage.com
Rocks!

Posts: 1

JB Weld Cam Chain Tensioner?
04/17/24 at 07:36:00

Having zero welding experience, a desire to DIY, and a tensioner which needs elongating, I am tempted to attempt affixing to the end a drilled piece of metal using JB weld epoxy. Is this a bad idea? The tube claims to be able to withstand over 4700 psi of force, but naturally, this bond is something I absolutely do not want to fail. Does this seem like a good idea? What other options do I have?

I have also seen photos of 3D printed extensions which attach at the original hole on the tensioner. Does anyone have a 3D model for this?

Thanks for looking!

IP Logged

Fast 650

Senior Member

Offline

SuzukiSavage.com
Rocks!

Posts: 396
Valrico, FL
Gender: male

Re: JB Weld Cam Chain Tensioner?
Reply #1 - 04/17/24 at 08:40:25

If it fails to hold, your wallet and your engine will both experience catastrophic damage. It is much cheaper and safer to find someone that can weld yours or just purchase a modified tensioner from Versy here on the forum. The Versy tensioner is pinned so it can't come apart inside your engine, which is another reason to go with the Versy tensioner.

IP Logged

ThumperPaul Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 1126 Houston, Texas Gender:	Re: JB Weld Cam Chain Tensioner? Reply #2 - 04/17/24 at 10:21:03 Bad idea. Trying to use a wad of JB Weld like some kind of super glue will fail between the stress and vibration. When it fails, you'll have a torpedo and scrap metal fying around in your engine case. Get the Versy cam chain tensioner.
Back to top	IP Logged

ohiomoto Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 2697 WTF is JOG?	Re: JB Weld Cam Chain Tensioner? Reply #3 - 04/17/24 at 17:31:38 Do it right or do it twice...and be prepared to spend a lot of money the second time.
Back to top	IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28790 L.A. California Gender:	Re: JB Weld Cam Chain Tensioner? Reply #4 - 04/17/24 at 19:20:31 Sure 4700 psi on a.150*.630 surface or .26 square inches equals 1119 pounds of strength versus the strength of steel 30,000 psi No welded steel is going to be much better
Back to top	Versey's Place Tech Section Index IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home