Donate!
Welcome, Guest. Please Login or Register :: View Members
Pages: 1 2 
Send Topic Print
bike will not start (Read 95 times)
springman
Serious Thumper
*****
Offline

SuzukiSavage.com
Rocks!

Posts: 2331
Spring, Texas
Gender: male
Re: bike will not start
Reply #15 - 11/09/26 at 13:55:50
 
Hello Versy. No, this battery is putting out good power. The loud clack when pressing the starter button almost sounds like a metal on metal hit.
Back to top
 
 

06 S40 seat mod, airhawk, HD muffler, Shinko 712 140-90-15 rear tire, Shinko 230 front tire, versy cam chain tensioner, Rotella oil, Volar brake pads, EBC clutch & springs
  IP Logged
youzguyz
Serious Thumper
*****
Offline



Posts: 2570
San Antonio, Texas
Gender: male
Re: bike will not start
Reply #16 - 11/10/26 at 02:59:04
 
Load clack could be the decomp solenoid.  Next step is to check for 12 volts at the starter while the starter button is depressed.  You get 12 volts, the starter solenoid is good and the problem could be the starter itself.
Back to top
 
 

2002 - Silver (Thumper)
2000 - Green (Mad Hamish)
Most motorcycle problems are caused by the nut between the seat and the handlebars. Make sure yours isn't too tight or too loose.
  IP Logged
springman
Serious Thumper
*****
Offline

SuzukiSavage.com
Rocks!

Posts: 2331
Spring, Texas
Gender: male
Re: bike will not start
Reply #17 - 11/10/26 at 09:11:21
 
Thanks Neal. I will give that a shot.
Back to top
 
 

06 S40 seat mod, airhawk, HD muffler, Shinko 712 140-90-15 rear tire, Shinko 230 front tire, versy cam chain tensioner, Rotella oil, Volar brake pads, EBC clutch & springs
  IP Logged
Axman88
Junior Member
**
Offline

SuzukiSavage.com
Rocks!

Posts: 79

Re: bike will not start
Reply #18 - 11/20/26 at 11:38:42
 
I've had starter problems that were eventually traced back to the heavy gauge cables, positive or ground, that carry current to the starter.  The cables oxidized under their protective insulation, internal resistance of the cable increased, eventually resulting in so much voltage drop within the cable itself, that the starter motor wouldn't turn the engine over.

"Voltage drop testing" is the technique that will reveal the specific culprit, if this is going on.  I found that the cables also tend to develop "rigid sections", which wouldn't flex as easily (Oxide is brittle), and these sections were also swollen (oxide has greater volume , lower density, than sound metal).  I'd use the voltage drop test as the ultimate test however, not the physical features.
Back to top
 
 
  IP Logged
Pages: 1 2 
Send Topic Print


« Home

 
« Home
SuzukiSavage.com
11/22/26 at 04:38:36



› General Category › Rubber Side Down! › bike will not start


SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.