SuzukiSavage.com - A stand to keep the bike upright?

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › A stand to keep the bike upright?

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

A stand to keep the bike upright? (Read 126 times)

och Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 617	A stand to keep the bike upright? 08/20/22 at 14:08:33 A bit of a noob question, but I am looking for some kind of a stand that will securely keep my bike upright, so I can check oil level and whatnot. Need something that isn't too bulky, but secure at the same time. This is both for my S40 and Star 950, so something that can accommodate a smaller and a larger bike.
Back to top	IP Logged

verslagen1 YaBB Moderator ModSquad Online Where there's a will, I want to be in it. Posts: 28786 L.A. California Gender:	Re: A stand to keep the bike upright? Reply #1 - 08/20/22 at 15:35:43 If you got jackstands, 1 under the right foot peg and 1 under the left engine bolt works great. but if you're just checking oil, then a 2x4 under the sidestand is vertical enough.
Back to top	Versey's Place Tech Section Index IP Logged

och

Serious Thumper

Offline

SuzukiSavage.com
Rocks!

Posts: 617

Re: A stand to keep the bike upright?
Reply #2 - 08/20/22 at 16:07:42

verslagen1 wrote on 08/20/22 at 15:35:43:

If you got jackstands, 1 under the right foot peg and 1 under the left engine bolt works great.

but if you're just checking oil, then a 2x4 under the sidestand is vertical enough.

I actually have a piece of 2.5" aluminum tube that I use under the jackstand, its almost vertical, but I'm looking for something to secure the bike. I down have a set of jackstands, but is there a device that hassle free?

IP Logged

Gary_in_NJ Serious Thumper Offline LS650 Cafe Racer Posts: 2629 Amongst the Twisty Roads	Re: A stand to keep the bike upright? Reply #3 - 08/20/22 at 16:43:42 Roll-on wheel chock. I use them for bikes without center stands.
Back to top	A life-time student of motorcycling. LS650 Cafe, DRZ400SM, FZ6N, SV650S, CB900C, Ducati ST2, CB550F-SS My LS650=> http://suzukisavage.com/yabb2.2/Attachments/Left.JPG IP Logged

och Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 617	Re: A stand to keep the bike upright? Reply #4 - 08/20/22 at 17:56:24 Gary_in_NJ wrote on 08/20/22 at 16:43:42: Roll-on wheel chock. I use them for bikes without center stands. Any particular one you can recommend?
Back to top	IP Logged

ohiomoto Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 2697 WTF is JOG?	Re: A stand to keep the bike upright? Reply #5 - 08/22/22 at 18:05:05 Harbor Freight I use tie-downs to stabilize the bike and a floor jack to lift the front or rear wheel when needed.
Back to top	IP Logged

Needles

YaBB Newbies

Offline

SuzukiSavage.com
Rocks!

Posts: 44
AR
Gender: male

Re: A stand to keep the bike upright?
Reply #6 - 08/25/22 at 17:12:03

I made one from the plan I saw in the tech pages. You're supposed to use a 4x8' board. I used two pieces of 2x8", glued and screwed, then drilled a 1" hole for the piece of conduit and put a floor flange on it upside down. Eight inches is high enough to let the bike sit nearly level. My wooden piece is 4 feet long, and I put screw eyes in the ends so I can stabilize it side to side with a couple of tie downs. Works well. Costs maybe $35 USD. I have a small garage and didn't want to have to store a bike lift. (I don't know about the 950.)

IP Logged

twhitus Full Member Offline SuzukiSavage.com Rocks! Posts: 101 Pinellas park, floida	Re: A stand to keep the bike upright? Reply #7 - 08/28/22 at 12:05:37 i have a orion motor tech motorcycle lift i got off amazon a few years ago and it works fine and should handle the weight of both bikes fine. the t-handle comes off and i just use my electric drill to raise/lower it. https://www.amazon.com/gp/product/B01M0AB7MJ/ref=ppx_yo_dt_b_search_asin_titl...
Back to top	IP Logged

Serowbot YaBB Moderator ModSquad Offline OK.... so what's the speed of dark? Posts: 28387 Tucson Az Gender:	Re: A stand to keep the bike upright? Reply #8 - 08/28/22 at 15:14:57 Rikko's Build Your Own Bike Lift/Stand http://suzukisavage.com/cgi-bin/YaBB.pl?board=tech;action=display;num=1100379341
Back to top	Ludicrous Speed !... ... ... IP Logged

TheSneeze Serious Thumper Offline Posts: 1203 Northern Nevada Gender:	Re: A stand to keep the bike upright? Reply #9 - 08/28/22 at 18:09:06 Slick... and inexpensive.
Back to top	Every twenty minute job is a stripped thread away from being a three day ordeal. '87 LS650h Savage Street Tracker '86 LS650g Savage (parts bike) '81 Kawasaki KZ750e ELR tribute IP Logged

och Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 617	Re: A stand to keep the bike upright? Reply #10 - 07/15/23 at 15:38:59 Do these rear stands work with the Savage?
Back to top	IP Logged

TheSneeze Serious Thumper Offline Posts: 1203 Northern Nevada Gender:	Re: A stand to keep the bike upright? Reply #11 - 07/15/23 at 17:01:57 You would have to take some measurements and do some research. You might get lucky, but I wouldn't buy it before I confirmed the specs on it.
Back to top	Every twenty minute job is a stripped thread away from being a three day ordeal. '87 LS650h Savage Street Tracker '86 LS650g Savage (parts bike) '81 Kawasaki KZ750e ELR tribute IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home