SuzukiSavage.com - Low Speed cut out?

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Low Speed cut out?

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Low Speed cut out? (Read 34 times)

Smith2

YaBB Newbies

Offline

Posts: 35

Low Speed cut out?
08/12/22 at 13:38:22

I installed the VM36 carb and it's been working great except for occasionally the engine shuts down when heavy deaccelerating. For instance, slowing down for a switchback. I do have a Biker's Choice Tachometer installed and working great. The idle, at least on the tach reads between 1100-1300. If I run turn the idle up to where it reads 1500, it doesn't seem to have the problem. I'm guessing the tach is reading a little high. After its been ridden awhile it tends to read about 500 rpm's higher.

So, with the needle bouncing between 1500-1900 rpms works fine. 1300-1500, intermittent shutdowns on deacceleration. Is my tach just read a little high or is my idle off? I read that the spec idle is 1300 and below 1000 the oil pump does not activate.

IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28890 L.A. California Gender:	Re: Low Speed cut out? Reply #1 - 08/12/22 at 15:15:02 the stock carb has a decel air valve that allows more air when decel'g. you'll need to do that manually with that carb.
Back to top	Versey's Place Tech Section Index IP Logged

Smith2 YaBB Newbies Offline Posts: 35	Re: Low Speed cut out? Reply #2 - 08/12/22 at 15:27:05 How's is that done manually?
Back to top	IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28890 L.A. California Gender:	Re: Low Speed cut out? Reply #3 - 08/12/22 at 21:40:56 Smith2 wrote on 08/12/22 at 15:27:05: How's is that done manually? with your wrist.
Back to top	Versey's Place Tech Section Index IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home