SCS40
Full Member
Offline
Riding again after a 19 year hiatus
Posts: 116
Easley, SC
Gender:
|
So I've had this bike about a year now and nearly doubled the odometer reading at purchase of about 5500 miles. While (and since) curing the no-start condition caused (eventually) by the failed petcock, I grew concerned about the decompression system.
Even with a fresh, stronger than OEM battery, the starter would sometimes stall, at least partly, before continuing to turn slowly and finally fire. This almost always happened when I was a hour or so from home. Not a comforting feeling/sound at all.
Also, during starting, my engine turned noticeably slower than other Savages I've seen and heard.
Finally, I never heard the "click" I've read so many times about as the solenoid engages. That is, until today.
I also worried perhaps my starter and or stator were lacking and close to failure.
I tried twice last year to adjust the cable. Neither time had any effect.
I priced a new solenoid and relay and balked at the prices.
Last week I ordered a used solenoid, complete with all hardware, for $10 on eBay. Today, I planned the install and oil change.
After gaining access, I initially planned to simply replace the outer "shell" of the solenoid. It seemed the easiest route.
Remembering the factory adjustment procedure, I tried (again) to compress the "inner" portion of the solenoid with the same result: nada.
It occurred to me while examining the eBay unit perhaps the problem wasn't the cable adjustment or electrical. Perhaps the solenoid was simply stuck. Perhaps dirt or corrosion had taken it's toll.
So, without removing anything else, I used a screwdriver to gain a little leverage and was (finally) able to compress the solenoid. I switched on the key and thumbed the starter.
Voila! NOW I know what the "click" sounds like and was able to see the system in action! Overly complicated for sure, but kinda neat. Still, I'd prefer a simple lever on the handlebar.
So, for free, my decompression system now works. I sprayed some WD40 about for good measure. Wish I'd tried this a year ago.
Before spending any money, or wasting time on adjustments you probably don't need, try working the solenoid manually first.
And if you do happen to need the solenoid, complete with all brackets, hardware, and cable, I have a spare!
|