SuzukiSavage.com - My helmet lock stopped working, any tips?

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › My helmet lock stopped working, any tips?

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

My helmet lock stopped working, any tips? (Read 49 times)

WolverineWinMX YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 29	My helmet lock stopped working, any tips? 07/31/19 at 15:56:54 My helmet lock stopped working with the ignition key and now my helmet is stuck on there. I tried squeezing a little WD-40 into the key hole to loosen it up but that didn't help. Next up I may have to take a hammer to it or drill it out.
Back to top	IP Logged

norm92de Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 1180 El Paso TX Gender:	Re: My helmet lock stopped working, any tips? Reply #1 - 07/31/19 at 17:05:20 Do you have more than one key? If so try the other one. I just looked at mine but can't come up with anything. Good luck.
Back to top	2014 S40. Raptor. idle mixture adj.Needle raised one notch. 4000' altitude. Stock jets. Shell Rotella synthetic. IP Logged

Hiko

Senior Member

Offline

SuzukiSavage.com
Rocks!

Posts: 250
Tauranga New Zealand
Gender: male

Re: My helmet lock stopped working, any tips?
Reply #2 - 07/31/19 at 18:03:40

Had a look at mine It is held on with a philips head machine screw into a tapped hole in the bracket which is then locked with a nut
from the back.
You could try taking off the locknut and attempting to undo the screw using
what is hanging out the back with vice grips or similar
If that fails you may be able to drill off the philips head by angling a drill down and then angling up from the bottom Fortunately there is only one screw there
You may be better to unbolt the whole bar off the guard and drill out the screw from the back

IP Logged

justin_o_guy2

Serious Thumper

Offline

What happened?

Posts: 55279
East Texas, 1/2 dallas/la.

Re: My helmet lock stopped working, any tips?
Reply #3 - 07/31/19 at 18:08:53

Try using graphite.
Work the key in and out
Till you're sick of it.

If all else fails
A firearm lock with a flexible loop will go around the handlebars and through a helmet loop

I have saddle bags and can't get to the helmet lock..
Which I never liked anyway
The helmet hangs just begging for someone to dump something in.

The people never give up their liberties but under some delusion.- Edmund Burke.

IP Logged

stewmills Serious Thumper Offline Imagination is more important than knowledge Posts: 2630 Auburn, AL Gender:	Re: My helmet lock stopped working, any tips? Reply #4 - 08/02/19 at 07:04:46 I have no immediate solution, but I recently bought a lock pick set to teach myself how to do it so I can go out and find me a new bike (JUST KIDDING) and I have only played with it a couple of times and picking locks is surprisingly easy. Maybe drive down to a locksmith...but take proof of ownership/title.
Back to top	2008 \| 152/52.5–Air Mix 3/4 \| RT6 w/Redline \| Seat Lift w/Sheepskin \| Speedo Rattle \| Rear Pulley Shim \| 140/90-15 Rear \| Kaw Front Pulley \| Relocated Rear Signals FREEDOM ISN'T FREE! IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28780 L.A. California Gender:	Re: My helmet lock stopped working, any tips? Reply #5 - 08/02/19 at 07:49:15 These locks are pretty simple. You might need to take the load off the lock (lift helmet) and wiggle the key.
Back to top	Versey's Place Tech Section Index IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home