I am cleaning my carburetor.
There was water in the floatbowl.
And there was a lot of dirt and rust in it. There is a hole that I cannot clean properly and I think there is a sprayer in it, because copper shavings head out. Does anyone know the size of this hole?
I cleaned the floatbowl.
THe hole is closed. and I tried to open it with a piece of thin iron wire. When I blow into it, I hear air flowing but the hole is very small.
On the back there is the number 22.
And when I drill with a thin drill bit, copper shavings come out.
so it's a jet. .
Does anyone know which size drill I can put through to completely clean it, without making the hole too large?
I have already tried everything, including an ultrasonic cleaner.
This is what claymer said about it: