SuzukiSavage.com - Carb Cable

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Carb Cable

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Carb Cable (Read 44 times)

hotrod Senior Member Offline SuzukiSavage.com Rocks! Posts: 326 NC Gender:	Carb Cable 04/27/19 at 13:03:04 I have a 36mm VM Mikuni carb and manifold. Just need a cable. Is there one from another model that I can use ?
Back to top	IP Logged

Dave

YaBB Moderator
ModSquad

Offline

SuzukiSavage.com
Rocks!

Posts: 17827
Camp Springs, Kentucky
Gender: male

Re: Carb Cable
Reply #1 - 04/28/19 at 04:49:42

Lancer has the proper cables for sale.....or you have to build your own.

I went to a bicycle shop and bought brake cables....and you can use some of the original cable parts if you need to. Soldering the stainless cable requires the correct flux and solder......and I found it is best to use a piece of metal held in a vice and a heated pool of solder to dip the cable in to "tin" it (trying it with the torch always overheated it).

Someday I will be old......But not today!

IP Logged

justin_o_guy2 Serious Thumper Offline What happened? Posts: 55279 East Texas, 1/2 dallas/la.	Re: Carb Cable Reply #2 - 04/28/19 at 09:30:53 Soldering the stainless cable requires the correct flux and solder. Radio Shack is gone. Where did you get that stuff? Excellent tips on How to get it done without cooking the cable.
Back to top	The people never give up their liberties but under some delusion.- Edmund Burke. IP Logged

Dave YaBB Moderator ModSquad Offline SuzukiSavage.com Rocks! Posts: 17827 Camp Springs, Kentucky Gender:	Re: Carb Cable Reply #3 - 04/28/19 at 12:30:21 Graingers
Back to top	Someday I will be old......But not today! IP Logged

justin_o_guy2 Serious Thumper Offline What happened? Posts: 55279 East Texas, 1/2 dallas/la.	Re: Carb Cable Reply #4 - 04/28/19 at 16:23:19 Good place.. I got a pound of 1/16" 60/40 flux core and it cost a little over Thirty Dollars now.. I didn't know there was a solder for stainless, and special flux, Any special cleaning/prep? Solder where it needs cut, then cut?
Back to top	The people never give up their liberties but under some delusion.- Edmund Burke. IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home