I'm in the process of replacing all of my gaskets on my motor. I was wondering if there were any prefered or recommended sealants that y'all use. I've gotten a lot of good help with my bike from this site, so any suggestions please through then at me! Thanks for your help

Did you split main cases ?
I install gaskets dry !
Main cases & rocker cover I use 3M 3bond !

I do the same thing the factory does.....Suzukibond sealant in those places where it belongs (center case seam, head cap cover), and I use factory gaskets everywhere else.

The only place I stray a bit from what the factory does is where the wires exit the case on the left for the charging system, and on the right for the neutral light - I put a small amount of sealant on the plug - as the rubber can get stiff and shrink as it ages.