09S40X
YaBB Newbies
Offline
SuzukiSavage.com Rocks!
Posts: 9
|
first off hello everyone, thanks for letting me be a part of suzukisavage.com I just purchased an 09 s40 it is my very first bike and I am a newb. first off it has 3800 miles and was straight piped when I got it, its really clean. I then drove it for a week then changed the oil and filter I used a k&n filter and mobil1 racing 4t 10w-40, the next day I put back on the factory muffler but tore out the main rear baffle first and im happy with the way it sounds. the next day it was harder to start, it used to fire right up with no choke, then 2 miles on my way to work it spits and sputters and dies and wont restart, 45 min later I get it to work and it fires right up, I let it sit until lunch let idle for 10 min went to go home it did it 1 mile into that trip and had to walk it back to work. I work at a dodge dealership in Idaho and have some knowledgeable technicians I have been consulting with. I then removed the carb and one of my technicians noticed the slide was sticking and cleaned it, so I put it back together and installed a k&n air filter at that time since I had it all apart, it then ran great for a week back and forth to work 3 miles one way and went on a 25mile ride during that time and was really happy with the way it rode, it has been harder to start though, I have had to use the choke when i didn't have to before, then was doing the same thing again yesterday a week later, but it would re start if it was choked then putter out again, I read about the hidden air fuel screw removed the cap and adjusted 1/2 turn out and no change, went all the way in then out 1 1/2 turns no change, out another 1/2 turn no change, then realized yesterday that the manual I downloaded was wrong about oil capacity, I put in 2.5 quarts like it said, it looked like It was just over the inspection window so I thought the level would be ok until I found out the right oil capacity, I drained it to the right level this morning and pulled the carb again to have one of my technicians inspect, as I said I am new to this whole bike thing and would like any recommendations on what I need to do to get it to run right and also any first timer tips on anything so I can make this the best bike as possible, I really hope I didn't f this thing up already with overfilling the oil, and the changes I have made I know have oil film on my rear fender im guessing from overfilling the oil, I hope I haven't blown any seals, I haven't seen any drips anywhere. please help. I really appreciate any input from you professionals here thank you I am looking forward to future upgrades and learning about this great bike I purchased I really like riding it.
|