Home
Forum
Search
Login
Register
Merch
Donate
Welcome, Guest. Please
Login
or
Register
::
View Members
SuzukiSavage.com
›
General Category
›
Rubber Side Down!
› Fork Brace Recommendations
(Moderators:
verslagen1
,
Dave
,
Serowbot
)
‹
Previous topic
|
Next topic
›
Pages:
1
2
3
Fork Brace Recommendations (Read 309 times)
Kenny G
Serious Thumper
Offline
SuzukiSavage.com The
Singles Club...LOL
Posts: 1754
Robson Ranch, Denton, Texas
Gender:
Re: Fork Brace Recommendations
Reply #15 -
07/26/16 at 09:44:11
Stew,
Where I found the T-Kat brace of most benefit is on roads that have the asphalt snakes running the same direction as the roadway. In North Texas that is virtually every road that I ride on.
Before I had a lot of wiggle on the snakes, after no perceivable wiggle.
Kenny G
Back to top
IP Logged
Paladin.
Serious Thumper
Offline
Hamster
Posts: 4929
Sunny Southern California
Gender:
Re: Fork Brace Recommendations
Reply #16 -
07/26/16 at 17:18:59
T-Kat is functional, the Superbrace is smoother. Both do the same job. I don't push the bike, but definitely noticed the bike was stabler with the brace.
Back to top
IP Logged
justin_o_guy2
Serious Thumper
Offline
What happened?
Posts: 55279
East Texas, 1/2 dallas/la.
Re: Fork Brace Recommendations
Reply #17 -
07/26/16 at 17:29:36
Mine was so stable I stopped using the sidestand when the wind wasn't over twenty MPH.
Back to top
The people never give up their liberties but under some delusion.- Edmund Burke.
IP Logged
old.indian
Serious Thumper
Offline
Fighting Foreign
Terrorism since 1492
Posts: 975
Central New Mexico
Gender:
Re: Fork Brace Recommendations
Reply #18 -
07/26/16 at 17:40:27
justin_o_guy2 wrote
on 07/26/16 at 17:29:36:
Mine was so stable I stopped using the sidestand when the wind wasn't over twenty MPH.
I see that you neglected to take your meds
AGAIN
...
Back to top
Lectron carb, modified head, stage 3 cam, Wiseco piston, header and Dyna, Varsi's cam chain adjuster, head plug and drilled rotor, Tkat, 12" shocks and 17/43 chain conversion.EdL's 4"FCs
IP Logged
justin_o_guy2
Serious Thumper
Offline
What happened?
Posts: 55279
East Texas, 1/2 dallas/la.
Re: Fork Brace Recommendations
Reply #19 -
07/26/16 at 18:44:48
I'll get back on them
First thing in the morning Chief,
Scouts Honor...
Back to top
The people never give up their liberties but under some delusion.- Edmund Burke.
IP Logged
stewmills
Serious Thumper
Offline
Imagination is more
important than
knowledge
Posts: 2641
Auburn, AL
Gender:
Re: Fork Brace Recommendations
Reply #20 -
07/26/16 at 19:55:47
So it looks like to install the tkat we have to remove the plastic fork shields, right? I was out measuring my forks per the tkat measure guide and it seems like the shields cover up the area that I need some measurements on but I don't want to just rip them off.
Is there a way to remove the shields safely or do I have to cut a slit in the back so I can peel them off?
Also, did those of you that got the tkat have to give detailed measurements or just your make, model, year and he took care of it? Said he has been making these for 30 years so I want to think he has a stockpile of measurements and knows what he's doing.
Back to top
2008 | 152/52.5–Air Mix 3/4 | Rotella T4 | Seat Lift w/Sheepskin | Speedo Rattle | Rear Pulley Shim | 140/90-15 Rear | Kaw Front Pulley | Relocated Rear Signals
FREEDOM ISN'T FREE!
IP Logged
verslagen1
YaBB Moderator
ModSquad
Offline
Where there's a
will, I want to be
in it.
Posts: 28903
L.A. California
Gender:
Re: Fork Brace Recommendations
Reply #21 -
07/26/16 at 20:04:26
I understand someone knocked them off with a piece of wood.
Back to top
Versey's Place
Tech Section Index
IP Logged
stewmills
Serious Thumper
Offline
Imagination is more
important than
knowledge
Posts: 2641
Auburn, AL
Gender:
Re: Fork Brace Recommendations
Reply #22 -
07/26/16 at 20:15:23
verslagen1 wrote
on 07/26/16 at 20:04:26:
I understand someone knocked them off with a piece of wood.
You're not referring to jog`s head are you?
Back to top
2008 | 152/52.5–Air Mix 3/4 | Rotella T4 | Seat Lift w/Sheepskin | Speedo Rattle | Rear Pulley Shim | 140/90-15 Rear | Kaw Front Pulley | Relocated Rear Signals
FREEDOM ISN'T FREE!
IP Logged
old.indian
Serious Thumper
Offline
Fighting Foreign
Terrorism since 1492
Posts: 975
Central New Mexico
Gender:
Re: Fork Brace Recommendations
Reply #23 -
07/26/16 at 20:23:05
stewmills wrote
on 07/26/16 at 20:15:23:
verslagen1 wrote
on 07/26/16 at 20:04:26:
I understand someone knocked them off with a piece of wood.
You're not referring to jog`s head are you?
Indubitably ....
Back to top
Lectron carb, modified head, stage 3 cam, Wiseco piston, header and Dyna, Varsi's cam chain adjuster, head plug and drilled rotor, Tkat, 12" shocks and 17/43 chain conversion.EdL's 4"FCs
IP Logged
Kenny G
Serious Thumper
Offline
SuzukiSavage.com The
Singles Club...LOL
Posts: 1754
Robson Ranch, Denton, Texas
Gender:
Re: Fork Brace Recommendations
Reply #24 -
07/26/16 at 20:36:43
Stew,
I just told him I had a 2013 S40 and he shipped the correct fork brace.
I split the seal protectors with a brand new utility knife blade and I could contact cement them back on if I ever removed the fork brace.
If you buy the brace make sure you cover the fender with cardboard when doing the installation to prevent scratching the paint.
Off topic, I am now using your rubber thingy on my rear wheel. I had a flat tire on an almost new rear tire on a hundred degree day.....
Kenny G
Back to top
IP Logged
Dave
YaBB Moderator
ModSquad
Offline
SuzukiSavage.com
Rocks!
Posts: 18137
Camp Springs, Kentucky
Gender:
Re: Fork Brace Recommendations
Reply #25 -
07/27/16 at 03:37:12
Yep....a small block of wood with a nice square corner, and a tap from a hammer will knock them out of the retaining grooves. You will have to work your way around before you drive any one side up very far. Work them up a little at a time.
Then....you need to decide if you want to cut them off so they aren't dangling around - or remove the fork tubes from the triple clamp so you can save the shields.
Back to top
Someday I will be old......But not today!
IP Logged
stewmills
Serious Thumper
Offline
Imagination is more
important than
knowledge
Posts: 2641
Auburn, AL
Gender:
Re: Fork Brace Recommendations
Reply #26 -
07/27/16 at 05:35:35
Thanks folks! That makes me feel better as I was not sure I was measuring very well.
I'll probably cut the shields off delicately to save them...I don't want to have to start taking apart the forks, etc.
KennyG, I hope the shim is working well for you. Hate to hear about the flat. I had a new rear last year with about 600 miles on it and picked up a nail. Rode too far to feel safe with the damage to the tire and had to buy a new tire and tube.
Back to top
2008 | 152/52.5–Air Mix 3/4 | Rotella T4 | Seat Lift w/Sheepskin | Speedo Rattle | Rear Pulley Shim | 140/90-15 Rear | Kaw Front Pulley | Relocated Rear Signals
FREEDOM ISN'T FREE!
IP Logged
stewmills
Serious Thumper
Offline
Imagination is more
important than
knowledge
Posts: 2641
Auburn, AL
Gender:
Re: Fork Brace Recommendations
Reply #27 -
08/11/16 at 12:28:15
So I got my TKAT in the mail today. For those that have had to remove the fork guards,
did you just use a piece of wood like this (see image) and give it a few whacks at the bottom lip of the plastic and it will then jump out of the groove?
My goal is to carefully split it down the middle (backside) to remove it from the fork so if I ever need to, I can snap it back on with a little glue and it still look nice. I thought cutting it first with a utility knife right there in the groove but I am trying to avoid scoring a line in the fork...and my hand
Thanks!
Back to top
IMG_20160811_124853.jpg
2008 | 152/52.5–Air Mix 3/4 | Rotella T4 | Seat Lift w/Sheepskin | Speedo Rattle | Rear Pulley Shim | 140/90-15 Rear | Kaw Front Pulley | Relocated Rear Signals
FREEDOM ISN'T FREE!
IP Logged
verslagen1
YaBB Moderator
ModSquad
Offline
Where there's a
will, I want to be
in it.
Posts: 28903
L.A. California
Gender:
Re: Fork Brace Recommendations
Reply #28 -
08/11/16 at 12:44:55
I found an image with the fork protectors removed.
It shows a locating notch on the inside next to the fender.
I think that's where I'd go after it.
Remove the fender, and wheel, put the wood there and give it a smack.
At least, this would be a hidden place in case YOU screw up.
Back to top
Versey's Place
Tech Section Index
IP Logged
stewmills
Serious Thumper
Offline
Imagination is more
important than
knowledge
Posts: 2641
Auburn, AL
Gender:
Re: Fork Brace Recommendations
Reply #29 -
08/11/16 at 12:59:32
Now...these are reportedly from a 1987, but I see no indents? I presume it is different on the 2008 model?
Back to top
Suzuki_LS650_Etu_putket.JPG
2008 | 152/52.5–Air Mix 3/4 | Rotella T4 | Seat Lift w/Sheepskin | Speedo Rattle | Rear Pulley Shim | 140/90-15 Rear | Kaw Front Pulley | Relocated Rear Signals
FREEDOM ISN'T FREE!
IP Logged
Pages:
1
2
3
‹
Previous topic
|
Next topic
›
Forum Jump »
» 10 most recent posts
» 10 most recent topics
General Category
»» Rubber Side Down!
- Technical Documents/Reference
- The Marketplace
- The Cafe
- Politics, Religion (Tall Table)
- Forum Upgrade Issues / Tests
« Home
« Home
SuzukiSavage.com
11/05/24 at 11:13:19
›
General Category
›
Rubber Side Down!
› Fork Brace Recommendations
SuzukiSavage.com
» Powered by
YaBB 2.2
!
YaBB
© 2000-2007. All Rights Reserved.