Hello everyone. Thought I would start a thread of my current bobber build. Its been a long, cold winter in Toronto, with record setting extreme cold weather alerts. March is here and I can feel the suns rays getting stronger. The build is coming along nicely, and I honestly could not have done it without the ideas and support from this forum. here ya go.....


The day I got her, with 33xxx kms on it.

aint she beautiful?.......not for long though

found a place for the regulator....mounted it on a peice of metal which I then screwed onto the inside of the fender mounting holes.

ignitor goes on top

I had a good idea for the cc breather....found a brass elbow at home depot in the plumbing section. I thought this was the best way to do it....but I was having difficulty securing the elbow to the inside of the filter. For now ill just go with a cc filter

cut and mounted the rear fender( just a 20$ trailer fender of course), finishing the edge comes later

cut the ugly horns off. At this point I got a piece of metal to form a seat pan and figure out my lines

a pic of the shed. Ive probably refilled that heater 50 times this winter....Also, my brand spanking new drill press on the left there.

Took off the handlebars to get a feel for what I want