SuzukiSavage.com - Valve seals

Donate!

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Valve seals

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

Valve seals (Read 67 times)

Thomas Högberg Junior Member Offline SuzukiSavage.com Rocks! Posts: 61 Vårgårda, Sweden Gender:	Valve seals 08/25/14 at 04:09:53 Hi about to replace my valve seals, do you just pull the old ones off with pliers or what? And what about the new ones, how do you seat them? /Thomas
Back to top	IP Logged

Dave YaBB Moderator ModSquad Offline SuzukiSavage.com Rocks! Posts: 18093 Camp Springs, Kentucky Gender:	Re: Valve seals Reply #1 - 08/25/14 at 04:55:19 I believe I just used a screwdriver to push up the bottom of them to pop them off. I don't believe seating them was anything more than just pushing them on with my fingers. I really don't remember it being anything difficult.
Back to top	Someday I will be old......But not today! IP Logged

Thomas Högberg Junior Member Offline SuzukiSavage.com Rocks! Posts: 61 Vårgårda, Sweden Gender:	Re: Valve seals Reply #2 - 08/25/14 at 04:58:42 Thanks Dave I will give it a try /Thomas
Back to top	IP Logged

Seaweednh Full Member Offline SuzukiSavage.com Rocks! Posts: 132 Newbury, MA Gender:	Re: Valve seals Reply #3 - 08/25/14 at 19:59:57 Is the head off or are you doing on the bike? On the bike you need to pressurize the cylinder to hold the valve shut. You can do this by modifying a spark plug or using the hose from a compression tester connected to an air compressor. Just oil the valve seals so they go on easier.
Back to top	IP Logged

Thomas Högberg Junior Member Offline SuzukiSavage.com Rocks! Posts: 61 Vårgårda, Sweden Gender:	Re: Valve seals Reply #4 - 08/25/14 at 22:22:41 Thanks Seaweednh for your tip The head is off the engine and the seals and valves are now mounted
Back to top	IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

« Home