Home
Forum
Search
Login
Register
Merch
Donate
Welcome, Guest. Please
Login
or
Register
::
View Members
SuzukiSavage.com
›
General Category
›
Rubber Side Down!
› pressing in new swing arm bearings
(Moderators:
verslagen1
,
Dave
,
Serowbot
)
‹
Previous topic
|
Next topic
›
Pages: 1
pressing in new swing arm bearings (Read 38 times)
Jsud04
Full Member
Offline
SuzukiSavage.com
Rocks!
Posts: 223
pressing in new swing arm bearings
08/17/14 at 13:22:53
I removed my old stock swing arm bearings because 28 yrs has left them...shot...for pressing in the new I was going to use a threaded rod and two pieces of steel. When threading the nuts on it should compress the bearing into place...
Is my logic sound?
Back to top
«
Last Edit: 08/18/14 at 03:35:55 by Dave
»
1986 red, raptor petcock, cham chain tensioner mod,carb plug pulled. DIY highway pegs, DIY ammo can storage...
IP Logged
verslagen1
YaBB Moderator
ModSquad
Online
Where there's a
will, I want to be
in it.
Posts: 28884
L.A. California
Gender:
Re: pressing in new swing arm bearings
Reply #1 -
08/17/14 at 13:32:49
Eye don't sea why knot.
Back to top
Versey's Place
Tech Section Index
IP Logged
verslagen1
YaBB Moderator
ModSquad
Online
Where there's a
will, I want to be
in it.
Posts: 28884
L.A. California
Gender:
Re: pressing in new swing arm bearings
Reply #2 -
08/17/14 at 14:34:57
This would make a good tech article.
Back to top
Versey's Place
Tech Section Index
IP Logged
Dave
YaBB Moderator
ModSquad
Offline
SuzukiSavage.com
Rocks!
Posts: 18096
Camp Springs, Kentucky
Gender:
Re: pressing in new swing arm bearings
Reply #3 -
08/18/14 at 03:37:59
Well.....maybe.
Most devices used for pulling with threads used very fine threads, and sometimes square threads to held reduce friction. Threaded rod is very coarse thread and you may not end up with enough pulling power.
You can try.....just lube those threads up really well and use the largest threaded rod you can fit/find/pay for.
Dave
Back to top
Someday I will be old......But not today!
IP Logged
Pages: 1
‹
Previous topic
|
Next topic
›
Forum Jump »
» 10 most recent posts
» 10 most recent topics
General Category
»» Rubber Side Down!
- Technical Documents/Reference
- The Marketplace
- The Cafe
- Politics, Religion (Tall Table)
- Forum Upgrade Issues / Tests
« Home
« Home
SuzukiSavage.com
09/22/24 at 18:29:34
›
General Category
›
Rubber Side Down!
› pressing in new swing arm bearings
SuzukiSavage.com
» Powered by
YaBB 2.2
!
YaBB
© 2000-2007. All Rights Reserved.