This annoying rattle from the speedometer overpowers the great exhaust sound so I needed to fix it

Start by removing the 2 bolts that hold on the seat





Now remove the 2 bolts and bracket that holds the rear of the tank (seat lift mod)


Now turn the raptor petcock to the off position and remove the fuel line(If you have the stock petcock you'll probably need to drain the gas and fully remove it)


Now lift the tank and pull towards the back of the bike


Disconnect the power supply to the cluster


Disconnect the speedometer cable


Dont lose the spacer gasket inbetween!


Now tip the tank up and get ready


Remove the 3 nuts holding the springs in, we will be reusing the 3 nuts and 3 washers


Now remove the speedo cable from the speedometer


Pull the speedometer from the top of the tank (notice I already put the fuel line onthe bolt side)


Now cut up some fuel hose a little longer then the spring, this will replace the spring and reduce the rattle


Slide everything on like this


Put the washers on first then tighten the nuts and then install the speedometer cable


Follow the steps backwards for reassembly! Thanks