SuzukiSavage.com - Parts bike purchase

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Parts bike purchase

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1 2

Parts bike purchase (Read 187 times)

S-P Serious Thumper Offline Back in the saddle again Posts: 816 Phoenix, AZ Gender:	Re: Toast or not? Reply #15 - 12/30/13 at 14:04:00 Rocker side
Back to top	rocker_side.jpg IP Logged

verslagen1 YaBB Moderator ModSquad Online Where there's a will, I want to be in it. Posts: 28884 L.A. California Gender:	Re: Toast or not? Reply #16 - 12/30/13 at 14:18:08 get some plastigap and see what the clearances are.
Back to top	Versey's Place Tech Section Index IP Logged

S-P Serious Thumper Offline Back in the saddle again Posts: 816 Phoenix, AZ Gender:	Re: Toast or not? Reply #17 - 12/30/13 at 14:32:55 Can I use the old cam? Will it be close enough to call with a new cam's dimensions or should I measure the old cam?
Back to top	IP Logged

justin_o_guy2 Serious Thumper Offline What happened? Posts: 55279 East Texas, 1/2 dallas/la.	Re: Parts bike purchase Reply #18 - 12/30/13 at 23:51:00 Tha cam journals otta be just fine. Theyre steel, its the aluminum head & cover that get eaten. Cam lobes & rockers get eaten, hafta look them over.,measure
Back to top	The people never give up their liberties but under some delusion.- Edmund Burke. IP Logged

S-P

Serious Thumper

Offline

Back in the saddle
again

Posts: 816
Phoenix, AZ
Gender: male

Re: Parts bike purchase
Reply #19 - 12/31/13 at 10:36:00

justin_o_guy2 wrote on 12/30/13 at 23:51:00:

Tha cam journals otta be just fine. Theyre steel, its the aluminum head & cover that get eaten. Cam lobes & rockers get eaten, hafta look them over.,measure

Yeah, the cam lobes are definitely worn out. Rockers feel like they have dished out a little too. The head doesn't look bad but I do need to do the plastigap thing to see if there's enough there to do the sanding trick. I'm thinking of going to our junkyard (I know they have a good wrecked motor) and picking up a cam there.

A quick question on the piston and cylinder... does the piston drop far enough down to see if there is a ridge at the rings?

IP Logged

Pages: 1 2

‹ Previous topic | Next topic ›

« Home