justin_o_guy2
Serious Thumper
Offline
What happened?
Posts: 55279
East Texas, 1/2 dallas/la.
|
Dont put the seat on till youve proven your wiring works,,
Do you have an ohm meter? If not, you need one & a test lite, I built mine, a socket for an 1156, coupla wires, a piece of piano wire sharpened to a needle point, a piece of dowel rod & some solder & black tape.,,. Only 20 minutes to build the replacement for my $2.00 junker.. I needed one & didnt want to go to town,,
A ground needs to be clean metal that is grounded, maybe you should run a wire from somewhere you KNOW is grounded, This stuff would be so much easier if I could see what youre doing,
Ohh,, & you can just run a wire, get a ground, anywhere, just run a wire & use it to prove the blinkers work IF you give them a good ground, If you run a wire from a known good ground & that doesnt solve it, then run a hot wire & prove they will at least get bright if you give them a straight 12 volts & a good ground,
The sockets & lamps, have you looked at them? Looked inside? Looked at the lamp connectors? All clean & tidy?
|