SuzukiSavage.com - rejetting for dyna?

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › rejetting for dyna?

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

rejetting for dyna? (Read 46 times)

RTC

Senior Member

Offline

SuzukiSavage.com
Rocks!

Posts: 260
El Paso, TX (Ft. Bliss)
Gender: male

rejetting for dyna?
04/06/10 at 14:55:35

I recently installed a dyna muffler and went to mess with the air mix screw for the first time. I turned it in until it bottomed out, counted the turns, and began to turn it out. I turned it out for almost 5 turns without noticing much loss in engine power, got a little concerned and set it to about 2.5 turns out where the engine sounded the strongest. do i need to rejet and what size? 155 main?

IP Logged

prechermike

Serious Thumper
Alliance Member

Offline

Kalashna Kitty, from
Skat

Posts: 1190
Ponzer, NC
Gender: male

Re: rejetting for dyna?
Reply #1 - 04/06/10 at 15:26:57

This is just my experience. I put on a dyna muffler and adjusted the air screw mix and that was that. I do not remember how many turns I made, but I did not rejet. But that is just my experience.

I have read on here many times that every bike is different and I believe it, I am close to sea level, near the coast. For what its worth!

2006, HD pipe, Tkat fork brace, elkhide handgrips, gel seat w/riser, silverblue, Ed L's forward controls, Wristwatch, biblethumper650@gmail.com

IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home