I have a 2003 Savage and would like to put a sportster seat on it for comfort.

I see a lot of sportster seats on e-bay and I need to know which seat will fit my bike the best.

I have a sissy bar and luggage rack and would like to keep them.

Any ideas?

Would I need the short tank version?

I see lots of sportster seats on e-bay, I just want to make sure that I get the right one.

Thanks again.

I think I ended up with an 04 sporty seat. The pan under the seat is flat and it doesn't want to sit down low enough onto our frame. I helped this by cutting out two egg sized pieces of the pan so that it sat down on the frame better. Then when I switched tanks the seat was too long cause the new tank was bigger. I pealed back the leather and cut off an inch or so of the front of the pan and restapled the pad and leather back on. My point is, if your not afraid to work on it you can make it fit and fit well. You'll need to fab a mounting bracket and figure out the rear mount. I bent the screw down tab on back of sporty seat so that it goes under the mounting location welded to out rear fender.
Seviersavage

A little wait and Corbin will have a seat made for our bikes. I put thousands of dollars into fixing both of our bikes and the 1500 mile trip. (I'll take donations to cover the costs of it  )

I only hope they make the same seats as the C90: a cruiser, a single, a rumble, and a gunfighter.

From what they said it'll be around 60 days or so until they get our bikes into production. But they have a 2001 LS650 and a 2005 S40 in their factory right now.