Donate!
Welcome, Guest. Please Login or Register :: View Members
SuzukiSavage.com › General Category › Rubber Side Down! › S40 Spark Plug Torque Spec
(Moderators: verslagen1, Dave, Serowbot) ‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
S40 Spark Plug Torque Spec (Read 54 times)
GM
YaBB Newbies
*
Offline

SuzukiSavage.com
Rocks!

Posts: 4
S40 Spark Plug Torque Spec
03/15/09 at 06:27:05  
I cannot find any reference to the torque spec for the spark plug on the 05 S40. Anyone have this information? Help is appreciated, for I have recently stripped two fasteners for the head to cylinder and just finished making helicoil repair. I haven't put the head back on as of yet, but am gun shy on tightening anything without a torque wrench.
Back to top
 
 
  IP Logged
craigq
Junior Member
Alliance Member
**
Offline

SuzukiSavage.com
Rocks!

Posts: 80
Ottawa, ON
Gender: male
Re: S40 Spark Plug Torque Spec
Reply #1 - 03/15/09 at 09:41:39  
I couldn't find one either, just the usual "1/2 turn past finger tight" for a new plug and "1/8 turn past finger tight" for a used plug.

FWIW most of my previous bikes were about 9.5 ft-lb to 12 ft-lb, 114 in-lb to 144 in-lb. I wouldn't go much higher than that...
Back to top
 
 
2009 WR250R/X
  IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›


« Home

 
« Home
SuzukiSavage.com
06/26/24 at 05:59:11



› General Category › Rubber Side Down! › S40 Spark Plug Torque Spec


SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.