SuzukiSavage.com - Help! Plug/Cap replacement problem wiht startup?

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Help! Plug/Cap replacement problem wiht startup?

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Help! Plug/Cap replacement problem wiht startup? (Read 116 times)

shermeco

Junior Member

Offline

SuzukiSavage.com
Rocks!

Posts: 65

Help! Plug/Cap replacement problem wiht startup?
06/02/08 at 19:59:46

Well, I did my plug/cap replacement today as well as rejetting the cabs with lancers jets. Put it all back together and the battery died. Before the battery died i tried starting it while in 1st gear with pushing in the clutch and it wanted to move on me it tried to drive any ideas what that might be before i try stating it again? thanks for any help you can give

« Last Edit: 06/03/08 at 18:21:35 by shermeco »

IP Logged

Reelthing Serious Thumper Alliance Member Offline Fish or ride that is the question Posts: 5397 Houston,Tx Gender:	Re: Plug/Cap replacement problem wiht startup? Reply #1 - 06/02/08 at 20:53:59 not sure I understand - you hit the start button while in gear with the clutch pulled in on a cold engine and it jumped a bit? - sounds proper to me
Back to top	IP Logged

shermeco Junior Member Offline SuzukiSavage.com Rocks! Posts: 65	Re: Plug/Cap replacement problem wiht startup? Reply #2 - 06/02/08 at 21:30:08 I have never had it jump like that before. Because when you have the clutch pushed in it is in neutral correct?
Back to top	IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28908 L.A. California Gender:	Re: Plug/Cap replacement problem wiht startup? Reply #3 - 06/02/08 at 21:50:28 you said you had it in 1st. kick stand up?
Back to top	Versey's Place Tech Section Index IP Logged

Max_Morley Serious Thumper Offline LT650 Luxury Touring & sidecar rig Posts: 1490 Moses Lake. WA Gender:	Re: Plug/Cap replacement problem wiht startup? Reply #4 - 06/02/08 at 21:55:33 Did you put the clutch release pin back in? It is easy for it to fall out when you remove or handle the RH (Clutch side) case cover. Max
Back to top	Max at Thumper Acres. '96 Savage bagger, '03 Savage w/Cozy sidecar for wifeni. IP Logged

shermeco Junior Member Offline SuzukiSavage.com Rocks! Posts: 65	Re: Plug/Cap replacement problem wiht startup? Reply #5 - 06/03/08 at 11:57:04 Update I worked on it today it seams fine but the battery would not take a charge so i went and bought a new one we will see in a few hours how that works out for me!
Back to top	IP Logged

shermeco

Junior Member

Offline

SuzukiSavage.com
Rocks!

Posts: 65

Re: Plug/Cap replacement problem wiht startup?
Reply #6 - 06/03/08 at 17:49:49

Update 2 some one please help
The solenoid will click when i push the starter but the starter wont turn over i used an meter to check to see if i was getting power to the starter directly and i was. So my question is what could be wrong. I checked between wires too and form the solenoid and got a connection there as well. when i alligator clipped to the starter it turned the fist time i did it but the next time it did not I'm so confused could some one please help me out

IP Logged

T Mack 1 - FSO

Serious Thumper
Alliance Member

Offline

sold 2001 LS650 for
a 1986 XLH1100

Posts: 2919
Emmaus,Pa
Gender: male

Re: Help! Plug/Cap replacement problem wiht startu
Reply #7 - 06/04/08 at 11:17:49

Details????

By Plug/cap do you meant the one inside the head cover?

If the bike moved when you hit the starter, then the clutch cable is out of adjustment or some other clutch issue. The interlock switch is at the clutch lever, and on a normally adjusted bike, the interlock will not let the starter buttom do anything if the lever is not in far enugh to make contact with the switch. But if it's out of adjustment.... you might make contact with the switch but still have the clutch slighly engaged.

Question, with the bike off, and bike in gear, and clutch lever pulled in, can you roll the bike?

Engineers design things, Technicians make them work.
---
30% of being mechanical is confidence/30% is knowing to go slow when needed/30% is looking repeatedly at what you have/10% is dumb luck Wink

IP Logged

shermeco Junior Member Offline SuzukiSavage.com Rocks! Posts: 65	Re: Help! Plug/Cap replacement problem wiht startu Reply #8 - 06/04/08 at 18:27:40 Yes I can roll the bike but i think i figured it out what was wrong it was the starter solenoid. I put up another post about that maybe you can help me with that.
Back to top	IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home