Ok more good and bad news. Always keep in mind no matter what you will always need a little fabrication.
Went to put on the the new switch. First thing i noticed was that the brake lever switch was different. I didn't think i had one but i realized what that was
anyway its different and i never had it working before so i pulled that whole assemble. Second the swith on the inside has a little tab. I guess the newer handle bars have a little hole where that little tab lines up and sits in my handle bars have no such hole so i got a pair of pliers and squeezed until i broke it the best i could now the switch sits flatter on the bars well acutally it fits perfect now. Problem number three. GUESS WHAT 87 and 99 SUZUKI ARE NOT THE SAME
the main plug is completly different well while trieng to figure what to do i broke the solder from one of the wires on the old switch so unless i was gonna solder i was going to have to make the new one work. So i followed the wires i needed did some splicing and connected my stock plug to the 99 switch and hooked it all up.
MY BIKE BLEW UP..... ???
j/k everything worked great. turn on the throttle cable sits nice everything looks good. I'm a happy camper. Except the right side looks so much newer than the right side hehehehehe
So to sum it up,
1 ) different brake switch but i dont use so i didn't care.
2) need to sand down or break off little tab inside switch
3) different plug so you need to splice some wires
Took me about 30 minutes to get it all done. and I LOVE IT.