I don't have the cafe' fairing, but I do have a very small 5" sorta' mini shield... It does very, very , little as far as wind protection, but it must do somethin'...
...

Any "Drag" bars, have a bit of angle to them, and will hit the tank without about 3" of riser... (you can make risers cheap)...
The only thing that will work without risers is clip-ons or wide, broomstick bars... (I'm not long enough for those to be comfy, especially with the stock forward footpegs)...

Jus' make some risers out of deep-well sockets, or other tubing...

Cut the one you have down to about 12"...
I have a stock 14" that I trimmed to 11" on my Sporty...
that puts the buffet zone at my collarbone... gives wind protection on my chest but no head buffet...

Use one of those Oscillating, multi-tool's with a half-round toothed blade, to cut... works real good...
This is a case of measure once, cut 3 times...
Go down 1" at a time, test,... and stop when you have the zone in the right place...
Once you have the size right,.. pretty up the cut...
I also,.. cut from the bottom, around the headlight, and kept sliding the mount down the fork tube,... the top edge remains factory perfect... it shows less that way...