SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> The Cafe >> Shop Tips-winter work! /cgi-bin/YaBB.pl?num=1510724248 Message started by zipidachimp on 11/14/17 at 21:37:28 |
Title: Shop Tips-winter work! Post by zipidachimp on 11/14/17 at 21:37:28 Walking through a home store, spotted a stack of glossy 24x24 ceramic tiles. Ran over to grab a steel yardstick, checked corner to corner, edge to edge, this sucker was FLAT! $7.00 ! Glued it to a 3/4" piece of MDF, got myself a shop surface plate for $10.00!!! Maybe not lab grade, but a good shop grade. Then blew a wad on blocks, squares and gauges. Cheers! 8-) |
Title: Re: Shop Tips-winter work! Post by Ruttly on 11/15/17 at 06:39:20 For surfacing heads & cases ? |
Title: Re: Shop Tips-winter work! Post by zipidachimp on 11/15/17 at 12:54:14 More as a means of measuring stuff. Not just for bikes, I also do woodwork. Got any tips to pass along? 8-) |
Title: Re: Shop Tips-winter work! Post by Ruttly on 11/15/17 at 15:17:30 I have a sheet of glass a tad smaller than that , it came off the front of a old tube type TV. I use it to check heads & cases for trueness and with some super fine sand paper & water I can wet sand to remove imperfections or high spots. It's about 1/4" thick tempered glass , had it for thirty years or so. |
Title: Re: Shop Tips-winter work! Post by zipidachimp on 11/15/17 at 21:26:27 Glass is good! Anyway, it's nice to have a very flat surface in a shop! Cheers! 8-) |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |