SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> springer front end
/cgi-bin/YaBB.pl?num=1228631320

Message started by il67bp on 12/06/08 at 22:28:40

Title: springer front end
Post by il67bp on 12/06/08 at 22:28:40

can someone give me the info i need to know for a springer front end swap. i think i need to know front axle width . i also would like to have a front caliper brake so anything that id need to know for that. and anything that has to do with the triple trees

Title: Re: springer front end
Post by Yonuh Adisi on 12/07/08 at 00:20:59

I swapped the entire front end front wheel and all for a Girder front end.

http://suzukisavage.com/cgi-bin/YaBB.pl?num=1213856449

Title: Re: springer front end
Post by Demin on 12/07/08 at 05:55:24

What I've been thinkin' is this.Almost,or all new springers are for Harley(somebody makes one to spec but it aint cheap.Can't rememeber who off hand)Probably use a Harley front wheel,brake,etc.Then the only thing would be the steering stem diameter,and length.Harley has a 1" dia. stem.They usually thread into the bottom tree.I had a stem made for a springer I'm putting on a Honda.They cut the threads to screw into the springer,machined the rest to the Honda specs.The machine shop I used was at home(in Ohio)I had to wait 'til he had time.but he only charged me around 50 bucks.  

SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.