SuzukiSavage.com - Trouble with Dyna Muffler

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Trouble with Dyna Muffler

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Trouble with Dyna Muffler (Read 34 times)

ClayJo

YaBB Newbies

Offline

SuzukiSavage.com
Rocks!

Posts: 2

Trouble with Dyna Muffler
Yesterday at 20:09:23

Hey guys, I recently bought a 2018 S40 and have followed this thread to rebuild and rejet my carb, install a raptor petcock and raise my seat. So here I am at the last piece of the Trifecta, doing the Dyna slip on. I bought the 65747-94 model which requires the least amount of work. I followed Serowbot's guide to install using tin can gasket and T bolt clamp but I cannot get this thing to seat fully. It stops with about a quarter inch gap left. I've attached photos. Any help us greatly appreciated. This is my first post so I hope I am following the proper procedure. - Clay

559518527_2869793760078353_4692481861838637871_n.jpg

IP Logged

blod Senior Member Offline SuzukiSavage.com Rocks! Posts: 322	Re: Trouble with Dyna Muffler Reply #1 - Today at 06:14:04 I used the exact same silencer on my Savage, I did not use a tin can gasket, it fitted perfectly without modification. I did not need to rejet the carb either Tip ! get one of these for a factory looking finish. https://www.ebay.ca/itm/174236617833?_skw=heat+shield+exhaust&epid=1704027501...
Back to top	IP Logged

ClayJo YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 2	Re: Trouble with Dyna Muffler Reply #2 - Today at 07:07:41 Did yours sit flush with the end of the downpipe? Did you need to hammer it on? I tried the tin can gasket but am having a leak. I followed the guide and cut slits down the flange to help it on but it looks like it tapers inside and gets caught at the very end of the downpipe :'(
Back to top	IP Logged

blod Senior Member Offline SuzukiSavage.com Rocks! Posts: 322	Re: Trouble with Dyna Muffler Reply #3 - Today at 08:16:58 I can't remember having to hammer it on, I think it was just a push fit. My silencer slits are not cut Try shortening your down pipe ( a little bit at a time ) so that it fits properly, it's less likely to leak then.
Back to top	IP Logged

uranusklingon YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 23	Re: Trouble with Dyna Muffler Reply #4 - Today at 10:46:42 I started doing the tin can gasket, but didn't care for it. I ended up just using some exhaust sealant goop from a tube from auto zone. Then I put an exhaust clamp on it. EVIL ENERGY 1.75" Heavy Duty U Bolt Exhaust Clamp, 1 3/4 Inch Stainless Steel U Muffler Clamps, Saddle Style, 2PCS
Back to top	raptor petcock, nibbi carb, sportster muffler, progressive shocks, memphis shooter windshield, dunlop D404's, superbrace, chinese rectifier, NGK iridium IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home