SuzukiSavage.com - Clutch replacement problem

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Clutch replacement problem

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Clutch replacement problem (Read 19 times)

Suzuki86prince

YaBB Newbies

Offline

SuzukiSavage.com
Rocks!

Posts: 24
victoria
Gender: male

Clutch replacement problem
03/07/25 at 18:53:17

Hey everyone,

I recently change all my clutch plates friction and steel.
I bought them from fortnine, I purchased 1-Barnett Clutch Friction Plate Kevlar, 5 Barnett Clutch Friction Plate Kevlar, 5
Barnett Steel Clutch Drive Plate 1.6mm thick, and the Barnett Clutch Spring Kit.
After putting all this back in the bike I have a lot of slack in the clutch. Like I have both set nuts loosed all the way out? Can any body give me any help.
I know there are different clutch pins but would that change after putting different plates in?

IP Logged

Surviving Philly Senior Member Offline SuzukiSavage.com Rocks! Posts: 293	Re: Clutch replacement problem Reply #1 - 03/10/25 at 14:48:52 Assuming the cable is correctly tensioned at the perch (handlebar) and the case, I think you probably screwed up the clutch re-assembly, just my two cents. https://www.youtube.com/watch?v=vJE6G0MjYbI&ab_channel=MiguelQuartermile Check out these videos from dragbikemike he runs through the entire job
Back to top	IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home