SuzukiSavage.com - Help! My bike wont run!

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Help! My bike wont run!

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1 2

Help! My bike wont run! (Read 100 times)

MrMangoTime YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 7	Re: Help! My bike wont run! Reply #15 - Yesterday at 18:20:59 ohiomoto wrote on Yesterday at 17:30:45: Sounds like a bad petcock to me. No its not the petcock. I've checked and double checked it. It runs off of engine vacuum and on prime just fine. and the carb is getting plenty of gas.
Back to top	IP Logged

ThumperPaul

Serious Thumper

Offline

SuzukiSavage.com
Rocks!

Posts: 1793
Houston, Texas
Gender: male

Re: Help! My bike wont run!
Reply #16 - Today at 05:11:20

A good thorough cleaning never hurts as long as you can get it all put back together correctly. If you use the dip bath method, make sure you remove all the o-rings and rubber parts (diaphragm and TEV diaphragm).

Good diagram of the carb in post #2 —> http://suzukisavage.com/cgi-bin/YaBB.pl?board=tech;action=display;num=1098869040

Removing Air/Fuel Mix Screw —> http://suzukisavage.com/cgi-bin/YaBB.pl?num=1350749896/0

If you decide to clean it or not, you have to get that A/F mix screw back in functional condition.

IP Logged

ThumperPaul

Serious Thumper

Offline

SuzukiSavage.com
Rocks!

Posts: 1793
Houston, Texas
Gender: male

Re: Help! My bike wont run!
Reply #17 - Today at 05:26:51

If you decide to make a paperweight out of the stock carb, here’s a post on my trials and tribulations installing the Keihin-style PWK38 —>

http://suzukisavage.com/cgi-bin/YaBB.pl?num=1714330191

A good starting point for the jetting is where I quit tinkering with mine:

Pilot Jet #32
Main Jet #125
E-clip in the middle groove on the needle (it comes this way when you buy it)

The manufacturer installed jets are HUGE. You can’t use those and you have to buy extra pilot and main jets. I’ve had good luck with the cheap jet kits you can buy on Amazon.

https://www.amazon.com/gp/aw/d/B07MMJV6BT?psc=1&ref=ppx_pop_mob_b_asin_title

IP Logged

ThumperPaul Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 1793 Houston, Texas Gender:	Re: Help! My bike wont run! Reply #18 - Today at 05:38:14 If you decide to go the Mikuni VM36/38 route, Lancer sells a complete kit. http://suzukisavage.com/cgi-bin/YaBB.pl?num=1338654578
Back to top	IP Logged

Pages: 1 2

‹ Previous topic | Next topic ›

« Home