Thankyou, Rutttly, I take that as a compliment.
As far as drawing the head in cad, this is what I have, and as a smart cookie over in one of the porting groups on Facebook said:"Spring seat saying: make my day" and of course that is where i will have my attention when I start to carve the inlet tract.
https://suzukisavage.com/yabb2.2/Attachments/inlet_port__20deg_001.JPGThe original seats are roughly 35mm, so there would not be much left of them, with an 88% throat. Therefore, I will fit 38mm valve seats.
That longer conrod is an intriguing option, and I wonder how much it would benefit, since there is not room for more than a few millimeters more than the stock item.
I was not too concerned about weight differences, considering that the poptop piston weighed quite a bit different than the stock one. I was thinking it would vibrate a bit more and probably at a slightly different RPM.
Carillo could match total weight within a few grams, and keep the ratio between big and small end correct too.
Cheers, Finn Hammer