Melissa wrote on 10/06/23 at 06:36:51:Were the ignition switch screwed into the frame it looks like it was broken so I'm not sure exactly how to reattach the switch in the same spot.
It just screws to 1 of the holes shown near the switch.
Quote:Also, the toggle switch has a black wire running to it from the positive side of the battery (right side) joining with the red wire that went to the ignition switch.
Just remove this wire.
Quote:Does a new ignition switch need to be touching the frame in the same spot to get ground?
No, some have remounted it elsewhere.
The gas cap, ignition, toolbox and helmet locks all are keyed to same key normally. If you have the old switch, take it to a locksmith and they should be able to make a key. If it still has the black strip on the bottom, you might be able to see the number. If so, you can order a key over the internet.