SuzukiSavage.com - Turn Signals Turn on Hazards

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Turn Signals Turn on Hazards

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Turn Signals Turn on Hazards (Read 39 times)

Dali2011

YaBB Newbies

Offline

SuzukiSavage.com
Rocks!

Posts: 2

Turn Signals Turn on Hazards
07/08/21 at 12:34:23

Hello,

First post on here but ive spent the past week going through the forums and I can’t find anyone with a similar issue. I picked up a 2011 Suzuki Boulevard s40 about two weeks ago. It has been running great. I installed a new Tachometer and a KN AirFilter (SU-6595) however I have been trying to troubleshoot this issue with the turn signals…

Whenever i go to use either the left or the right turn signals the Hazards come on, as in all four turn signals and the turn signal indicator lights all flash in the same speed as when I use the actual Hazard lights button.

I have switched out the relay at the front of tank with no luck. I have also tested the continuity in the left hand cluster according to the Clymer Manual and the switches all work as expected. When I disconnect the relay completely the front turn signal lights stay on but the rear stay off.

At this point I am not sure what components to check or where to go next. Any help or suggestions would be appreciated. I have a simple ohmmeter if anyone has something they think I should check

IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28890 L.A. California Gender:	Re: Turn Signals Turn on Hazards Reply #1 - 07/08/21 at 15:27:25 I suspect you have a short. The hole in the headlight where all the wiring runs thru is where I'd look 1st.
Back to top	Versey's Place Tech Section Index IP Logged

Dali2011 YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 2	Re: Turn Signals Turn on Hazards Reply #2 - 07/08/21 at 19:08:18 verslagen1 wrote on 07/08/21 at 15:27:25: I suspect you have a short. The hole in the headlight where all the wiring runs thru is where I'd look 1st. How would I go about testing this with the Ohmmeter? I’ve seen the wiring diagram but im not sure how it all works
Back to top	IP Logged

verslagen1

YaBB Moderator
ModSquad

Offline

Where there's a
will, I want to be
in it.

Posts: 28890
L.A. California
Gender: male

Re: Turn Signals Turn on Hazards
Reply #3 - 07/08/21 at 20:05:47

Dali2011 wrote on 07/08/21 at 19:08:18:

How would I go about testing this with the Ohmmeter? I’ve seen the wiring diagram but im not sure how it all works

You would need a microOhm meter to be able to read the length of the wire between short and the connector otherwise it'll be either infinite and 0.

Remove the wire from the bucket and look for burn spots.

Versey's Place
Tech Section Index

IP Logged

Yoshi Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 874 LongIsland, N.Y. Gender:	Re: Turn Signals Turn on Hazards Reply #4 - 07/09/21 at 20:09:29 Are your blinkers oem or aftermarket? How long have you had the light problem?
Back to top	IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home