SuzukiSavage.com - Junking the vacuum carb

Donate!

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Junking the vacuum carb

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

Junking the vacuum carb (Read 43 times)

Mark Huppertz YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 5	Junking the vacuum carb 06/08/20 at 20:05:25 I want to replace my sluggish, troublesome diaphragm carb with a mechanical slide carb. Do I need a 40 mm?
Back to top	IP Logged

ZSteele Senior Member Offline I'll finish it tomorrow Posts: 253	Re: Junking the vacuum carb Reply #1 - 06/08/20 at 20:43:51 Most will point you to a vm36 or a vm38 if you have heavy engine mods already. Lancer has a kit.
Back to top	IP Logged

DragBikeMike Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 4230 Honolulu	Re: Junking the vacuum carb Reply #2 - 06/09/20 at 00:56:28 I think you might find this carburetor shootout useful. It compares four different carbs, and provides installation & jetting info. http://suzukisavage.com/cgi-bin/YaBB.pl?num=1585461605 Good luck.
Back to top	Knowledge is power. IP Logged

Gary_in_NJ Serious Thumper Offline LS650 Cafe Racer Posts: 2629 Amongst the Twisty Roads	Re: Junking the vacuum carb Reply #3 - 06/09/20 at 04:55:04 If you have a stock engine the CV carb is well suited to the performance characteristics of the 650 engine. If your carb is properly adjusted, it should be neither troublesome or sluggish. What steps have to taken to get the CV operating correctly?
Back to top	A life-time student of motorcycling. LS650 Cafe, DRZ400SM, FZ6N, SV650S, CB900C, Ducati ST2, CB550F-SS My LS650=> http://suzukisavage.com/yabb2.2/Attachments/Left.JPG IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

« Home