SuzukiSavage.com - Looking for a vacuum plug cap

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › The Marketplace › Looking for a vacuum plug cap

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Looking for a vacuum plug cap (Read 53 times)

WolverineWinMX YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 29	Looking for a vacuum plug cap 08/23/19 at 10:22:18 I replaced my stock petcock with the Yamaha Raptor petcock and did a temporary seal of my vacuum plug by folding up the rubber tubing there and zip tying it. Does anyone have an extra vacuum plug cap they can gift me? I can pay for the stamps/shipping. The auto parts store here wants like $7 for a pack of 4. I just need one. Thanks!
Back to top	IP Logged

Eegore Serious Thumper Online SuzukiSavage.com Rocks! Posts: 7988	Re: Looking for a vacuum plug cap Reply #1 - 08/23/19 at 10:33:08 I don't have a plug but just an FYI I hose-clamped the folded rubber tubing on mine years ago and its never failed. If you just want a cleaner look I understand the cap, or a bullet casing with sealant. If you don't care just snag a hose clamp and it will work fine until that hose rots which could be years away.
Back to top	IP Logged

ohiomoto Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 2681 WTF is JOG?	Re: Looking for a vacuum plug cap Reply #2 - 08/23/19 at 12:23:52 The PO of my bike folded and zip tied the tubing AND put silicone in the end. It has lasted years and still works great. You can shove a bolt or some other plug in there too.
Back to top	IP Logged

verslagen1

YaBB Moderator
ModSquad

Offline

Where there's a
will, I want to be
in it.

Posts: 28752
L.A. California
Gender: male

Re: Looking for a vacuum plug cap
Reply #3 - 08/23/19 at 13:19:06

A modified rivet will do the job.
I have a bunch of flat head rivets that are slightly smaller than the vac port ID. I put it in a vice and compressed it until it was a tight fit. Then I hammered it in. To remove it takes a pin punch from the other side.

A round head rivet with a little RTV would work too.

But I've been meaning to try a 1/4" copper tubing solder cap with RTV.

Versey's Place
Tech Section Index

IP Logged

prechermike Serious Thumper Alliance Member Offline Kalashna Kitty, from Skat Posts: 1190 Ponzer, NC Gender:	Re: Looking for a vacuum plug cap Reply #4 - 08/30/19 at 09:40:12 I stuck a small yellow wire nut in mine, it was suppose to be temporary, but it's still there.
Back to top	2006, HD pipe, Tkat fork brace, elkhide handgrips, gel seat w/riser, silverblue, Ed L's forward controls, Wristwatch, biblethumper650@gmail.com IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home