it’s Wednesday my doods.
Happy hump.
Will a bad Cam chain Tensioner effect my clutch ?
Seems like I don’t have enough tension ... kinda answered my own question there huh.

All my gears work , I can change real fast slowing down or speeding up without clutch but when I pull in clutch it does not do anything at all

The throw out is sintered metal and has been known to break.
If you didn't mess around inside the clutch cover and you can pull the clutch and nothing happens, something is busted.
Watch the lever on the engine
Pull the clutch lever
If it doesn't move
Cable is busted
Look up under the clutch lever
If the cable breaks there
It's not swiveling in the pocket, bending the cable
Breaking the tiny wires until it dies.

Grab the lever on the engine
If you are not a lumberjack and you can move it up , your throwout died.
Mine busted the rear cam chain guide too.

Here’s what I’m dealing with at the moment

We've seen this before, a small piece of flat bar steel,  drilled and tapped to the solid  remaining part of the case in between the cables, with proper size holes for the clutch cable  , and over size hole for the speedo nut ,would work nicely , the bottom nut is the cable adjustment and the top nut is just for locking it down  ,both go on top. this fix will work as all the force on the plate would be downward when you squeeze in the clutch handle. paint it silver and it almost disappears.(it's been done by others and sure beats doing a complete motor teardown and a new casing half.)