SuzukiSavage.com - Mixture screw installation

Donate!

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Mixture screw installation

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

Mixture screw installation (Read 32 times)

edison YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 25	Mixture screw installation 05/26/18 at 06:52:28 Putting the carb back together after cleaning..... Installation of the mixture screw is first the seal> washer >spring then mixture screw, correct? Can I place it in as a single unit (i.e. washer and seal on the screw or do they go in separately?). Still trying to figure out the spring's function. Thanks!
Back to top	IP Logged

norm92de Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 1180 El Paso TX Gender:	Re: Mixture screw installation Reply #1 - 05/26/18 at 07:29:49 Edison, The function of the spring is friction, to prevent the screw from turning due to vibration. You have the order correct it all goes in together. Very gently and carefully.
Back to top	2014 S40. Raptor. idle mixture adj.Needle raised one notch. 4000' altitude. Stock jets. Shell Rotella synthetic. IP Logged

edison YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 25	Re: Mixture screw installation Reply #2 - 05/26/18 at 09:15:22 Thanks again!
Back to top	IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

« Home