PerroVivo
YaBB Newbies
Offline
Bobber power!
Posts: 28
Tucson, AZ
|
Hello,
Hope to get some suggestions on my next steps for troubleshooting.
Here is the story: Bike was running just fine, the bike started and ran for about 1 block then for no obvious reason it just lost power and stalled. Now, the bike does starts, but struggles to stay on... after the bike stalls, there seems to be white smoke/fume that comes out of the air box.
The following is what I done to find the issue: - I made sure the valves are to spec, by putting it on TDC and adjust valves clearance to .5 -Took the top of the case off to check on the chain and timing... I looks fine. -Compression test was in the low 100. -Pull carbs apart and clean all components. -New carb diagram… replace awhile a go. -Petcock is a brass fitting, open and flows with no problem. -Tried 2 different spark plugs. -There is no apparent oil leak.
I recently simplify the starting wiring system, in the process I put in some new staff (new solenoid, new coil, new spark plug, new(used) CDI, new pickup coil, new stator, new negative wire to case)
Any Suggestions on what my next step may be troubleshooting wise?
I will try to take a video later today, greatly appreciate any suggestions.
|