SuzukiSavage.com - Gear shifter seal replacement?

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Gear shifter seal replacement?

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Gear shifter seal replacement? (Read 41 times)

darkclwnz YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 4	Gear shifter seal replacement? 01/31/18 at 13:52:16 Has anyone here done this to their bike yet .. I'm wondering how hard it is? any advice? Thanks in advance!
Back to top	IP Logged

kojones Full Member Offline SuzukiSavage.com Rocks! Posts: 223 Finland	Re: Gear shifter seal replacement? Reply #1 - 02/01/18 at 00:06:55 darkclwnz wrote on 01/31/18 at 13:52:16: Has anyone here done this to their bike yet .. I'm wondering how hard it is? any advice? Thanks in advance! Not hard at all. Tilt the bike to the right side and you don’t have to drain the oil. The axle seal is very common size and doesn’t have to be purchased from Suzuki.
Back to top	IP Logged

darkclwnz YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 4	Re: Gear shifter seal replacement? Reply #2 - 02/01/18 at 02:10:31 Does it just pop out with needle nose pliers essentially?
Back to top	IP Logged

Dave

YaBB Moderator
ModSquad

Offline

SuzukiSavage.com
Rocks!

Posts: 18101
Camp Springs, Kentucky
Gender: male

Re: Gear shifter seal replacement?
Reply #3 - 02/01/18 at 04:21:29

The easiest way to replace a seal that has the shaft in place, is to take a sharp punch and a hammer and make a few small holes around the seal. Then put some small sheet metal screws in the holes, and use side cutting pliers to grab the screws and pry out the seal. Be careful not to nick the shaft with the punch or pliers.

Someday I will be old......But not today!

IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home