Home
Forum
Search
Login
Register
Merch
Donate
Welcome, Guest. Please
Login
or
Register
::
View Members
SuzukiSavage.com
›
General Category
›
The Cafe
› Piezo Blinker Bulb? Will it work?
(Moderators:
verslagen1
,
Dave
,
Serowbot
)
‹
Previous topic
|
Next topic
›
Pages: 1
Piezo Blinker Bulb? Will it work? (Read 57 times)
stewmills
Serious Thumper
Offline
Imagination is more
important than
knowledge
Posts: 2641
Auburn, AL
Gender:
Piezo Blinker Bulb? Will it work?
04/27/17 at 12:04:00
Many of us have performed the mod to add either a piezo or LED indicator to remind us our turn signals are on. Instead of doing the mod/hack into the relay, would this bulb work if placed in a rear socket? Couldn't use in the front because it runs all if the time. Could only see using this in the rear where it beeps at each "blink" of the rear signal.
https://www.delcity.net/store/Back!Up-Lights/p_809850.h_818678
Back to top
2008 | 152/52.5–Air Mix 3/4 | Rotella T4 | Seat Lift w/Sheepskin | Speedo Rattle | Rear Pulley Shim | 140/90-15 Rear | Kaw Front Pulley | Relocated Rear Signals
FREEDOM ISN'T FREE!
IP Logged
Dave
YaBB Moderator
ModSquad
Offline
SuzukiSavage.com
Rocks!
Posts: 18099
Camp Springs, Kentucky
Gender:
Re: Piezo Blinker Bulb? Will it work?
Reply #1 -
04/27/17 at 12:17:58
The light is made to go into a back up light.....so when the power is on, the light stays on continuously and the alarm alternates on/off. I don't know what it would do if you put it in the turn signal where the power goes on/off to make the light blink (and you would need one bulb for each rear turn signal).
Back to top
Someday I will be old......But not today!
IP Logged
stewmills
Serious Thumper
Offline
Imagination is more
important than
knowledge
Posts: 2641
Auburn, AL
Gender:
Re: Piezo Blinker Bulb? Will it work?
Reply #2 -
04/27/17 at 12:25:43
Well darn. I didn't think about it like that but I understand now...its for the clear back-up light fixture on a vehicle that is always on while in reverse, not intermittent.
Case closed
Back to top
2008 | 152/52.5–Air Mix 3/4 | Rotella T4 | Seat Lift w/Sheepskin | Speedo Rattle | Rear Pulley Shim | 140/90-15 Rear | Kaw Front Pulley | Relocated Rear Signals
FREEDOM ISN'T FREE!
IP Logged
SALB
Serious Thumper
Offline
FSO
Posts: 668
Whittier, AK
Gender:
Re: Piezo Blinker Bulb? Will it work?
Reply #3 -
04/27/17 at 12:30:16
I'm not sure the bulb would fit in the signal housing. Another option might be a flasher unit with the beeper built in, if they make the right size for our bike.
Something like this...
http://www.turnalarm.com/
Back to top
IP Logged
stewmills
Serious Thumper
Offline
Imagination is more
important than
knowledge
Posts: 2641
Auburn, AL
Gender:
Re: Piezo Blinker Bulb? Will it work?
Reply #4 -
04/27/17 at 12:37:03
SALB, good find and I see their approach but probably not money I would spend.
I have an LED indicator on my bars that is hacked into the flasher relay and it works pretty well. If I ever did anything else (in the absence of another cheap option) I would just add a piezo to my current wiring. Just thought that if that bulb was a solution it would be a really cool thing for a lot of people here.
Back to top
2008 | 152/52.5–Air Mix 3/4 | Rotella T4 | Seat Lift w/Sheepskin | Speedo Rattle | Rear Pulley Shim | 140/90-15 Rear | Kaw Front Pulley | Relocated Rear Signals
FREEDOM ISN'T FREE!
IP Logged
Kenny G
Serious Thumper
Offline
SuzukiSavage.com The
Singles Club...LOL
Posts: 1754
Robson Ranch, Denton, Texas
Gender:
Re: Piezo Blinker Bulb? Will it work?
Reply #5 -
04/27/17 at 13:54:23
Stew,
I added two of the Piezo Beepers to my LED Pilot Light Circuit. I can hear the beepers at very low speed with my helmet on and hopefully remember to look at the LED Blinker so I remember to cancel the turn signals soon after the turn.
Age is not user friendly....
Kenny G
Back to top
IP Logged
stewmills
Serious Thumper
Offline
Imagination is more
important than
knowledge
Posts: 2641
Auburn, AL
Gender:
Re: Piezo Blinker Bulb? Will it work?
Reply #6 -
04/27/17 at 13:56:27
Thanks, Kenny. I have debated getting a piezo to add to mine, but like most things I just haven't gotten around to it. When you purchased your piezo, did you have to shop for a certain type or voltage? I may tinker around and add one someday.
Back to top
2008 | 152/52.5–Air Mix 3/4 | Rotella T4 | Seat Lift w/Sheepskin | Speedo Rattle | Rear Pulley Shim | 140/90-15 Rear | Kaw Front Pulley | Relocated Rear Signals
FREEDOM ISN'T FREE!
IP Logged
Kenny G
Serious Thumper
Offline
SuzukiSavage.com The
Singles Club...LOL
Posts: 1754
Robson Ranch, Denton, Texas
Gender:
Re: Piezo Blinker Bulb? Will it work?
Reply #7 -
04/27/17 at 14:18:49
Stew,
I am not sure about voltage. I bought a package of 5 of them from Amazon or one of the Chinese direct merchants they were cheap. I cannot imagine that they make them in more than one voltage.
Kenny
Back to top
IP Logged
stewmills
Serious Thumper
Offline
Imagination is more
important than
knowledge
Posts: 2641
Auburn, AL
Gender:
Re: Piezo Blinker Bulb? Will it work?
Reply #8 -
04/27/17 at 14:28:19
Do you remember what dB (decibel) rating yours are? If you can barely hear yours I would want to step it up a notch
Back to top
2008 | 152/52.5–Air Mix 3/4 | Rotella T4 | Seat Lift w/Sheepskin | Speedo Rattle | Rear Pulley Shim | 140/90-15 Rear | Kaw Front Pulley | Relocated Rear Signals
FREEDOM ISN'T FREE!
IP Logged
Dave
YaBB Moderator
ModSquad
Offline
SuzukiSavage.com
Rocks!
Posts: 18099
Camp Springs, Kentucky
Gender:
Re: Piezo Blinker Bulb? Will it work?
Reply #9 -
04/28/17 at 03:59:09
SALB wrote
on 04/27/17 at 12:30:16:
I'm not sure the bulb would fit in the signal housing. Another option might be a flasher unit with the beeper built in, if they make the right size for our bike.
Something like this...
http://www.turnalarm.com/
SALB: The 552LL would work - you would likely just have to cut off the stock wiring connector and crimp in 2 spade terminals to connect to the flasher. (The 552 would most likely work as well - but it is a thermal flasher and depends on the resistance of the bulbs to set the flasher rate......and if anyone converted to LED turn signals it would not work).
Back to top
Someday I will be old......But not today!
IP Logged
Kenny G
Serious Thumper
Offline
SuzukiSavage.com The
Singles Club...LOL
Posts: 1754
Robson Ranch, Denton, Texas
Gender:
Re: Piezo Blinker Bulb? Will it work?
Reply #10 -
04/28/17 at 09:34:16
Stew,
I don't remember the decibel count. The reason that I put two buzzers on was one was not loud enough.
Kenny G
Back to top
IP Logged
Pages: 1
‹
Previous topic
|
Next topic
›
Forum Jump »
» 10 most recent posts
» 10 most recent topics
General Category
- Rubber Side Down!
- Technical Documents/Reference
- The Marketplace
»» The Cafe
- Politics, Religion (Tall Table)
- Forum Upgrade Issues / Tests
« Home
« Home
SuzukiSavage.com
09/29/24 at 00:29:00
›
General Category
›
The Cafe
› Piezo Blinker Bulb? Will it work?
SuzukiSavage.com
» Powered by
YaBB 2.2
!
YaBB
© 2000-2007. All Rights Reserved.