tlitteer wrote on 04/18/17 at 07:42:22:
Gary_In_Nj, what carb jets are you using for your setup?
That's a good question. I've had no reason to revisit my carb since I first jetted it, so over the years, I've forgotten. I'm fairly certain that I'm running a 152.5 Main and 52.5 Pilot and a #40 washer on the needle. I've also drilled out the fuel screw cover - start at 1.5 turns out and adjust as required.
The reason I think these are my setting is because this is what RYCA suggests in their tuning documentation (which they got from this forum) and it just worked for me. I used the #40 washer rather then shaving the spacer as shaving the spacer seemed unprecise and unrepeatable.
I'm running the RYCA quiet reverse cone and the K&N.