Arcreefer wrote on 09/25/16 at 21:31:23:Back on point... what does the main jet washer look like? is it metal or rubber?
thick brass
Quote: I'll pull the carb tomorrow and look. I'm planning on adding a washer to the jet needle anyway.
both can be done with carb in place... a lot easier.
the bat box tends to get in the way of the bowl drop.
use a strap to pull it back.
Quote:I was also wondering if it might be a vacuum issue with the tank? low rpm and it locks up, high rpm and it flows?
if it were vacuum, it would shut off after a while.
Quote: Also, I need the screw set for the carb. Do you (Verslagen) sell those? Also need the Versy, etc.,
See dave's thread in the marketplace, not sure if he's still selling them.
tech section has carb specs, screw sizes shown towards the end.